Kenmore Dishwasher 587.718500 (587718500, 587 718500) Parts

Left arm hinge component for dishwasher doors. Replaces broken, cracked, or worn hinge arms that cause door alignment issues or prevent proper closing.

Dishwasher fastening clip secures internal components like racks and panels. Replace if broken, loose, or missing to restore proper fitment. Verify compatibility with your model number before ordering.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

Replacement caster wheel for your dishwasher. Mounts to the bottom of the unit to allow smooth rolling. Replace if cracked, broken, or no longer rolls.

Dishwasher plate vent gasket seals the vent assembly to prevent leaks and maintain proper drying. Replace if cracked, worn, or causing moisture issues.

This refrigerator door gasket creates an airtight seal around the door to help maintain proper temperature and energy efficiency. Replacing a damaged gasket restores sealing performance and helps prevent cold air loss. What it does

• Seals the refrigerator compartment to keep cold air in and warm air out
• Helps maintain consistent cooling and reduces frosting/condensation
• Prevents food spoilage related to poor door sealing
• Reduces excessive run time caused by air leaks

• One door gasket as shown

• Clean and dry the door frame before installing to ensure a proper seal
• Soften the gasket in warm water or use a hair dryer on low to ease positioning if needed
• Start installation at the corners, working around the door to seat the gasket evenly

This is a #4-40 x 5/8" machine screw used to secure panels, trim, and small assemblies on compatible appliances. It replaces missing or stripped fasteners to restore secure mounting and reduce vibration or rattling. What it does:

• Fastens panels, brackets, and small components where a #4-40 x 5/8" machine screw is specified
• Helps stop loose trim, control panels, or interior parts that can vibrate or shift
• Restores proper alignment when missing or damaged screws cause gaps or movement
• Matches OEM thread pitch and length used in the original assembly

• One #4-40 x 5/8" screw

• Use the correct #4 Phillips or compatible driver to avoid cam-out and head damage
• Start threading by hand to ensure proper engagement before tightening
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic parts
• Disconnect power to any electrical appliance before working on panels or internal components