Kenmore Dishwasher 587.736712 (587736712, 587 736712) Parts

Fix poor upper rack cleaning in your dishwasher with this impeller and seal kit. Restores water pressure to the upper spray arm. Moderate DIY repair.

This is a metal plate that mounts behind the control panel of a range, acting as a protective shield for wiring and electronic components. It helps block heat from the oven cavity and prevents grease or debris from reaching sensitive parts. Replace this plate if it is warped, corroded, or damaged, which could expose control components to excessive heat or contamination.

This is a mounting screw used to secure panels, brackets, or other components inside or on the exterior of a freezer. It ensures parts remain firmly attached during normal operation. Replace this screw if it is stripped, corroded, or missing, which can cause loose or rattling components.

Right side trim panel for dishwashers. Replaces cracked, broken, or missing exterior trim. Installs along the right edge to restore clean appearance.

Replace your dishwasher's O-ring seal to stop leaks and maintain proper water pressure. This wear part prevents water damage when worn or cracked.

Replace your dishwasher's silverware basket if cracked, broken, or missing. This removable basket holds utensils securely during wash cycles.

This refrigerator door gasket creates an airtight seal around the door to help maintain proper temperature and energy efficiency. Replacing a damaged gasket restores sealing performance and helps prevent cold air loss. What it does

• Seals the refrigerator compartment to keep cold air in and warm air out
• Helps maintain consistent cooling and reduces frosting/condensation
• Prevents food spoilage related to poor door sealing
• Reduces excessive run time caused by air leaks

• One door gasket as shown

• Clean and dry the door frame before installing to ensure a proper seal
• Soften the gasket in warm water or use a hair dryer on low to ease positioning if needed
• Start installation at the corners, working around the door to seat the gasket evenly

This is a #4-40 x 5/8" machine screw used to secure panels, trim, and small assemblies on compatible appliances. It replaces missing or stripped fasteners to restore secure mounting and reduce vibration or rattling. What it does:

• Fastens panels, brackets, and small components where a #4-40 x 5/8" machine screw is specified
• Helps stop loose trim, control panels, or interior parts that can vibrate or shift
• Restores proper alignment when missing or damaged screws cause gaps or movement
• Matches OEM thread pitch and length used in the original assembly

• One #4-40 x 5/8" screw

• Use the correct #4 Phillips or compatible driver to avoid cam-out and head damage
• Start threading by hand to ensure proper engagement before tightening
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic parts
• Disconnect power to any electrical appliance before working on panels or internal components