Kenmore Refrigerator 596.79242011 (59679242011, 596 79242011) Parts

Protective cover for the high voltage control unit in your refrigerator. Replace if cracked, broken, or missing to protect electrical components.

Collects defrost and condensation water under the freezer drain area. Replace if cracked, warped, or leaking to prevent puddles and water damage.

This plastic filter cover protects the dishwasher's filter and sump, helping keep food and debris out of the pump while directing wash water through the filter area for proper draining and cleaning performance. What it does:

• Covers and secures the filter/sump area so debris is trapped before reaching the pump
• Helps channel wash water through the filter for effective filtering and draining
• Reduces risk of pump clogs and noisy operation from loose debris
• Commonly replaced when cracked, warped, or not seating properly which can cause poor draining or food re-deposit

• Disconnect power to the appliance before performing any service
• Remove the lower rack and lift out the filter assembly to access the cover
• Inspect and clean the filter and sump area before installing the new cover
• Refer to the appliance's diagram for correct orientation and fastening

Replacement support rod for refrigerator shelves and components. Secures and aligns parts that shift or sag. Order when your rod is bent, broken, or missing.

Secures and seals the water filter in its housing. Replace if cracked, broken, or missing to restore a proper fit after filter changes.

Left side housing cover for refrigerators. Replaces cracked, broken, or missing housings. Installs on the left side to restore appearance and protection.

Replace your refrigerator's light cover lens when cracked, yellowed, or missing. Protects interior bulb and provides clear illumination. Confirm fit with your model.

Plastic cover cap that conceals and protects wire connections in your refrigerator. Replace if cracked, broken, or missing for a clean finish.

Replaces cracked, broken, or worn refrigerator door hinges. Secures and aligns the door for proper closure. Available in multiple finishes to match.

Housing cover for refrigerators. Protects internal components and provides structural support. Replace if cracked, broken, or missing for proper fit.

This slide is the replacement guide that lets an oven or warming drawer open and close smoothly, restoring proper support and alignment for the drawer. Durable, low-profile fit that helps reduce sticking and uneven movement. What it does:

• Guides and supports the oven/warmer drawer during use for smooth sliding action
• Helps prevent the drawer from binding, catching, or coming off the track
• Reduces noise and uneven movement caused by worn or damaged guides
• Restores correct alignment so the drawer closes flush and operates reliably

• Disconnect power to the appliance before beginning any repair
• Remove the drawer per the appliance service instructions to access the existing slide
• Compare the new slide to the old part for proper orientation before installing
• Tighten fasteners securely and test drawer operation; do not force components

Replacement door frame trim that covers the door opening edge. Install when original trim is cracked, chipped, scratched, or missing to restore appearance.

Refrigerator shelf retainer clip secures shelves and bins in place. Replace if cracked, broken, or shelves won't stay secure. Confirm fit with model number.

Small mounting clip that secures panels and trim inside your refrigerator. Replace when broken, cracked, or missing to restore proper fit and stability.