Kenmore Dishwasher 665.13173K703 (66513173K703, 665 13173K703) Parts

This interconnect board links the range/oven control console to the main electronics, restoring signal and power routing so the console and control functions communicate correctly. Designed as a direct replacement circuit connector. What it does:

• Routes signals and power between the user control console and the main control board
• Restores communication for touchpad/controls and display functions
• Can resolve symptoms like an unresponsive control panel, blank or flickering display, or failure to start cooking cycles
• Helps correct intermittent electronic behavior caused by loose or damaged connector circuitry

• Disconnect power at the breaker or unplug the appliance before beginning work
• Handle the board by the edges and avoid static discharge; use anti-static precautions if available
• Verify connector orientation and fully seat all ribbon cables and wire harnesses during reassembly

Color: Black - Part has been changed to an Access Panel Kit - The toe panel is no longer used.

This fine screen is the small mesh filter that sits in the dishwasher sump to catch food particles and help protect the pump and wash system. It keeps debris from circulating so dishes rinse more effectively. What it does:

• Traps food and debris in the sump to prevent clogging and pump damage
• Helps maintain proper water flow for consistent wash and drain performance
• Reduces risk of food redepositing on dishes during cycles
• Commonly replaced when torn, heavily clogged, or missing

• One fine mesh sump screen

• Turn off power and disconnect the dishwasher before servicing
• Remove the lower dish rack and access the sump area to replace the screen
• Inspect surrounding seals and housing for damage while servicing
• No special tools typically required; handle mesh gently to avoid deformation

This disk valve diverter directs wash water flow between spray arms and wash zones to restore proper circulation and cleaning performance. It replaces a worn or damaged diverter to help return consistent spray pressure and distribution. What it does:

• Routes pump water to the correct spray arm or wash zone during the wash cycle
• Helps maintain even spray pressure for effective cleaning
• Worn or broken diverter can cause poor cleaning, reduced water to a spray arm, or unusual pump noise
• Prevents bypass flow that can reduce wash performance

• One disk valve diverter as shown

• Disconnect power to the appliance and shut off the water supply before starting
• Access may require removing the tub access panel or disassembling spray arm/tub components
• Inspect surrounding seals and gaskets; replace any damaged parts to prevent leaks
• After installation, run a short cycle and check for proper water routing and leaks

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Also order air vent seal

The Whirlpool push on retainer nut is an OEM replacement part responsible for securing the heating element in the dishwasher. It is located in the base of the dishwasher's tub to hold the heating element firmly in place. The push-on retainer nut keeps the heating element securely connected to the dishwasher's electrical system while allowing for easy removal and replacement when necessary.

Over time, push on retainer nuts can become loose, worn out, or damaged due to regular use, vibrations, or accidental mishandling. If a retainer nut fails, it can lead to parts becoming unstable or disconnected.

Symptoms of a bad push on retainer nut include:

• Loose or unstable dishwasher components
• Parts falling off or becoming misaligned
• Unusual noises during the wash cycle
• Difficulty in securing components within the dishwasher

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models