Kenmore Range 665.72163301 (66572163301, 665 72163301) Parts

White metal cooktop panel that covers the top of your gas range. Replace if cracked, chipped, stained, or showing wear from years of cooking use.

If your burner flame is uneven or yellow, or the burner sits loose, the burner box may need replacement. Restores proper gas flow and alignment.

Splicing 25 Ft. Black 12 Ga. 150~c (Wire, Red 14 Ga. 200~c)

Lower heat shield for gas ranges. Protects internal components from heat damage. Replace if cracked, warped, or missing to maintain proper heat distribution.

Protective cover that shields the range igniter assembly. Replace if cracked, broken, or missing to protect internal igniter components from damage.

Replace your cracked, chipped, or missing range burner cap. This component sits on top of the burner head to direct flames evenly during cooking.

This thermostat senses appliance temperature and helps the control maintain proper cooling. It replaces a failed temperature switch to restore reliable temperature regulation and protect components from overheating. What it does

• Monitors temperature and signals the control board or compressor to turn cooling on or off
• Prevents overheating by opening the circuit when temperatures exceed safe limits
• Commonly replaced when the appliance does not reach or maintain the correct temperature
• Can stop intermittent cooling or continuous-run symptoms when the original thermostat fails

• One thermostat as shown

• For experienced DIYers only; disconnect power before servicing
• Follow manufacturer instructions and verify correct part placement and wiring before restoring power
• Do not modify the part; use proper tools and replacement hardware

This fixed thermostat monitors and helps regulate appliance temperature to maintain safe operation and reliable cooling/heating. It replaces a worn or failed thermostat to restore proper cycling and temperature control. What it does:

• Opens or closes a circuit at a set temperature to control heating or cooling cycles
• Prevents continuous run by signaling the system to stop when the desired temperature is reached
• Commonly used to address symptoms like no temperature control, compressor or heater running nonstop, or failure to reach set temperature
• Works as a safety/control device to reduce risk of overheating when operating correctly

• One fixed thermostat

• Disconnect power before servicing to avoid shock or injury
• Locate and access the thermostat per your model's service instructions (typically mounted near the evaporator, heater, or air path)
• Handle carefully and avoid bending or damaging terminals; verify function with a multimeter if equipped

Burner baffle for gas ranges. Sits under the burner cap to distribute flames evenly. Replace if cracked, warped, or corroded for proper heat distribution.