Kenmore Compactor 665.7496001 (6657496001, 665 7496001) Parts

Replacement spring that provides tension to hold the trash compactor container securely in place. Install when original spring is worn, stretched, or broken.

Supports the rotating shaft in your trash compactor, reducing friction for smooth operation. Replace if you hear grinding noise or the ram sticks.

Replacement drive hub that secures the compactor's power screw to the transmission. Needed when the original hub is worn, cracked, or broken.

Size: 10-24 x 3/8 inch.

This latch assembly secures the trash compactor drawer in the closed position and engages the safety interlock that allows the compactor to operate. It mounts to the front of the compactor frame and connects to the door switch mechanism. Replace this part if the drawer will not latch shut, the compactor fails to start because it does not detect a closed door, or the latch mechanism is visibly broken or worn.

Left side frame slide for trash compactors. Replaces cracked, broken, or worn slides that support the compactor drawer. Essential structural component.

Conical washer for trash compactor assemblies. Maintains tension under screws or bolts to keep components aligned. Replace if worn, cracked, or missing.

Fix parts sliding off shafts or shifting during compaction. This C-ring snaps into grooves to secure components and prevent axial movement in your compactor.

Size: 6-32 x 3/8 inch.

Size: 8-32 x 1/4 inch.

Holds compactor bags securely during operation. Replace if cracked, broken, or handles are damaged. Installs inside compactor drum for easy bag removal.

For use on power screw and ram pressure pads. Size: 4 oz. can.

This is a black plastic handle that attaches to the front of the trash compactor drawer, allowing you to pull the drawer open and push it closed. It serves as the primary grip point for operating the compactor's waste drawer. Replace this handle if it is cracked, broken, or if the mounting tabs have snapped off, making it difficult to open or close the drawer.

Fix a trash compactor that won't turn on or off with this control switch. Direct replacement part installs in minutes with basic tools.

This precision thrust race serves as the hardened bearing surface for axial loads in a rotating mechanism. Replacing a worn race reduces friction and noise, helping restore smooth, consistent motion and protect companion thrust bearings and washers from accelerated wear.

• Provides the hardened bearing surface for a thrust bearing assembly
• Supports axial load and helps maintain proper end-play in the mechanism
• Reduces friction to allow smoother rotation under load
• Wear may present as grinding/scraping noises, rough or binding motion, excessive axial play, or visible scoring

• Disconnect power and shut off water/gas before servicing
• Access the thrust-bearing area; note the order and orientation of races, bearings, and washers for reassembly
• Clean mating surfaces; replace any worn companion parts and lubricate only if specified by the service documentation
• Seat the new race fully and verify free movement by hand before reassembly and testing

Metal mounting bracket that secures internal components in your trash compactor. Replace if bent, damaged, or missing to restore stable part alignment.