Kenmore Compactor 665.8401002 (6658401002, 665 8401002) Parts

Supports the rotating shaft in your trash compactor, reducing friction for smooth operation. Replace if you hear grinding noise or the ram sticks.

Size: 10-24 x 3/8 inch.

Conical washer for trash compactor assemblies. Maintains tension under screws or bolts to keep components aligned. Replace if worn, cracked, or missing.

Left side frame slide for trash compactors. Replaces cracked, broken, or worn slides that support the compactor drawer. Essential structural component.

Fix parts sliding off shafts or shifting during compaction. This C-ring snaps into grooves to secure components and prevent axial movement in your compactor.

Slotted pin spring secures moving parts in trash compactor assemblies. Replace if worn, missing, or damaged to restore proper retention and alignment.

Size: 6-32 x 3/8 inch.

Size: 8-32 x 1/4 inch.

Flat metal washer distributes load and maintains proper alignment between fasteners and components. Replace when worn, corroded, or missing. Confirm fit with your model number.

Replace your trash compactor's broken or stripped drive gear assembly. Includes gears, shafts, and components that transfer motor power to the ram mechanism.

Holds compactor bags securely during operation. Replace if cracked, broken, or handles are damaged. Installs inside compactor drum for easy bag removal.

This is a black plastic handle that attaches to the front of the trash compactor drawer, allowing you to pull the drawer open and push it closed. It serves as the primary grip point for operating the compactor's waste drawer. Replace this handle if it is cracked, broken, or if the mounting tabs have snapped off, making it difficult to open or close the drawer.

Replacement drive hub that secures the compactor's power screw to the transmission. Needed when the original hub is worn, cracked, or broken.

This latch assembly secures the trash compactor drawer in the closed position and engages the safety interlock that allows the compactor to operate. It mounts to the front of the compactor frame and connects to the door switch mechanism. Replace this part if the drawer will not latch shut, the compactor fails to start because it does not detect a closed door, or the latch mechanism is visibly broken or worn.