Kenmore Range 790.36679400 (79036679400, 790 36679400) Parts

It was a little tricky. I watched a video it helped a little . Took the door apart, that was the easy part, BUT putting it back, could not remember sequence of parts. I would suggest take a picture of each piece as you remove them that would help. Read more

It was easy to replace the old clock/timer control board with the new one. I followed these steps: 1. Remove the four control knobs. 2. Remove the four large plastic nuts under the control knobs. This holds down the entire faceplate. 3. Remove the four screws which secure the clock/timer control board and display. 4. Lift up the control board, and remove the multi-pin connector (needed to use a flathead screwdriver to pry open connector tabs). 5. Replace old control board with new control... Read more

After replacing the burner twice and verifying the fuel holes and orifice was not blocked, we fixed the problem by replacing the wiring harness P/N: AP3965774. That and making sure the burner was tightly screwed into the range base to ensure the correct spark gap. Read more

Ordered a new clock/timer control. This was very easy to install the real trick was removing about 8 wires and 4 plug in connectors from the board and then reinstalling them back in the same location as the were before. I took a photo of the board with my IPhone before taking all the wires off, this made it very easy to reinstall the wires on the same terminals as before. There are 2 additional connectors on the board that a flat ribbon cable from the touch button panel attaches to. Do not just... Read more

Replaced both door hinge receptacles Read more

Got a replacement wire Read more