Kenmore Cooktop 790.43000700 (79043000700, 790 43000700) Parts

This front control panel replaces a cracked, faded or damaged console surface to restore the appliance's appearance and provide a secure mounting surface for the range's controls and user interface. Fits the factory mounting points for a direct replacement. What it does

• Provides the outer face and mounting surface for the oven/range control buttons, switches and display.
• Restores a clean, undamaged console surface that protects underlying electronics and wiring.
• Addresses symptoms like visible cracks, dents, peeling finish or loose console trim.
• Helps ensure buttons and control hardware mount correctly and operate without interference.

• Includes: one replacement front control panel.

• Disconnect power to the appliance before beginning any work to avoid electrical shock.
• Remove control knobs and any trim pieces, then unfasten screws holding the panel; support the panel while detaching wiring/connectors.
• Handle the panel carefully to avoid scratching the finish; inspect and transfer any gaskets or mounting clips from the old panel if needed.

Housing assembly for cooktop induction control board. Protects internal electronics and wiring. Replace if cracked, damaged, or missing components.

This Box & Wires Assembly is the factory wiring junction used to route and connect electrical circuits for the appliance. It replaces a damaged junction box and wiring to restore safe, reliable electrical connections. What it does:

• Provides a protected junction point for internal appliance wiring and connectors
• Routes power and control signals between components through pre-attached wires
• Commonly installed when wiring is frayed, connectors are broken, or the junction box is cracked
• Helps eliminate intermittent power, non-responsive controls, or component failures caused by poor connections

• Turn off and disconnect power at the breaker before accessing internal wiring
• Verify correct wire routing and secure all connector clips to prevent pinching
• Use appropriate fasteners and follow OEM wiring diagrams for proper grounding

Specs: 10-32 X 0.375