Kenmore Range 790.45062401 (79045062401, 790 45062401) Parts

Mounting plate that secures the power cord set to the back of your range. Replace if the original plate is cracked, broken, or missing during installation.

Insulation blanket that wraps around the oven cavity to retain heat and reduce exterior surface temperatures. Replace if torn, compressed, or missing.

Upper trim mounting bracket for ranges. Secures trim panels to the appliance body. Replace if bent, cracked, or missing to restore proper trim fit.

White right side door trim for your range. Replaces cracked, chipped, or discolored trim pieces. Restores a clean finished look to your oven door edge.

White left side door trim for your range. Replaces cracked, broken, or discolored trim pieces. Restores the finished appearance of your oven door.

Installation instructions manual for your range. Replacement guide for lost, damaged, or missing documentation. Includes setup and care guidelines.

Replace your range's control panel trim if it's cracked, discolored, or broken. This cosmetic panel covers the control area for a finished look.

Replace your range's control panel trim if cracked, discolored, or damaged. This decorative panel covers the control area for a finished appearance.

This trim piece fits around the appliance control panel to restore a finished appearance and protect edges from wear. It replaces worn or damaged trim to keep controls looking clean and aligned. What it does:

• Provides a finished border around the control panel for a factory appearance
• Protects panel edges from chips, dings, and everyday wear
• Helps keep control buttons and display area sealed from gaps where grime can collect
• Restores proper alignment and fit between the control console and door or fascia

• One trim piece as shown

• High-level replacement; typically fastened with screws or clips accessible from the front or inside the console
• Power off and disconnect the appliance before beginning to avoid electric shock
• Handle trim gently to avoid scratching the finish; use non-marring tools as needed
• Obtain OEM replacement screws/clips rather than reusing compromised parts