Kenmore Range 790.46109300 (79046109300, 790 46109300) Parts

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Plastic spacer that positions and supports the heating element in your range cooktop. Replace if cracked, broken, or missing to properly secure the element.

Insulation panel for ovens and ranges. Installs inside the oven cavity to provide heat retention and sound dampening. Replace if torn, compressed, or missing.

Rubber or plastic bushing that cushions and supports the oven door. Replace if cracked, worn, missing, or causing door misalignment or rattling.

Insulates and cushions the oven cabinet interior. Replace if cracked, damaged, or missing to restore thermal separation and reduce condensation.

This end cap cover replaces a worn or broken trim piece to restore a finished look and secure an exposed edge. It keeps components aligned and helps prevent snagging or debris buildup along the opening. What it does:

• Covers and protects the exposed end of a cabinet, rail, or trim section
• Helps keep adjoining parts seated and aligned for smooth operation
• Prevents sharp or rough edges from causing snags or minor damage
• Reduces dirt and debris accumulation in the covered gap

• Unplug the appliance or disconnect power before attempting service when applicable
• Inspect the mating surface for broken tabs or debris and clean before installing
• Align the cap with mating slots or rails and press or snap into place; secure with the original fastener if required
• If tabs are damaged, replace any broken retainers to ensure a secure fit

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening

Replace the upper main back panel on your range. This structural panel covers the rear upper section. Order a new one if yours is damaged, rusted, or missing.