Kenmore Range 790.46129300 (79046129300, 790 46129300) Parts

Oven not heating or baking unevenly? This lower bake element restores proper heating for even cooking. Moderately easy DIY repair in 30-45 minutes.

Range door gasket creates an airtight seal for efficient heating. Replace if worn, cracked, or oven loses heat. Verify fit with your model number.

Insulation panel for ovens and ranges. Installs inside the oven cavity to provide heat retention and sound dampening. Replace if torn, compressed, or missing.

Rubber or plastic bushing that cushions and supports the oven door. Replace if cracked, worn, missing, or causing door misalignment or rattling.

Insulates and cushions the oven cabinet interior. Replace if cracked, damaged, or missing to restore thermal separation and reduce condensation.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

This end cap cover replaces a worn or broken trim piece to restore a finished look and secure an exposed edge. It keeps components aligned and helps prevent snagging or debris buildup along the opening. What it does:

• Covers and protects the exposed end of a cabinet, rail, or trim section
• Helps keep adjoining parts seated and aligned for smooth operation
• Prevents sharp or rough edges from causing snags or minor damage
• Reduces dirt and debris accumulation in the covered gap

• Unplug the appliance or disconnect power before attempting service when applicable
• Inspect the mating surface for broken tabs or debris and clean before installing
• Align the cap with mating slots or rails and press or snap into place; secure with the original fastener if required
• If tabs are damaged, replace any broken retainers to ensure a secure fit

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening

Replace the upper main back panel on your range. This structural panel covers the rear upper section. Order a new one if yours is damaged, rusted, or missing.