Kenmore Range 790.46139300 (79046139300, 790 46139300) Parts

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

This is the electric heating element located inside the warming drawer of a range. It provides low, steady heat to keep cooked food warm until serving. Replace this element if the warming drawer no longer heats, heats unevenly, or if the element is visibly damaged or burned out.

Ignitor orifice assembly for gas cooktops. Mounts near the burner to position the ignitor for proper spark. Replace if cracked, damaged, or missing.

Range door gasket creates an airtight seal for efficient heating. Replace if worn, cracked, or oven loses heat. Verify fit with your model number.

Insulation panel for ovens and ranges. Installs inside the oven cavity to provide heat retention and sound dampening. Replace if torn, compressed, or missing.

Rubber or plastic bushing that cushions and supports the oven door. Replace if cracked, worn, missing, or causing door misalignment or rattling.

Insulates and cushions the oven cabinet interior. Replace if cracked, damaged, or missing to restore thermal separation and reduce condensation.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

This ignitor orifice assembly controls gas flow to the oven burner and provides the proper delivery point for ignition. It helps restore reliable ignition when the burner sparks but won't light or produces a weak flame. What it does:

• Directs gas through the correct orifice to the oven burner for ignition
• Works with the igniter to allow consistent lighting of the bake/broil burner
• Can resolve symptoms such as burner not lighting or a very small/uneven flame
• Replaces a damaged, clogged, or improperly seated orifice assembly

• One ignitor orifice assembly

• Turn off power to the appliance and shut off the gas supply before starting work
• Handle with care and avoid forcing connections; light fittings may be fragile
• After installation, check for gas leaks and proper ignition before regular use

This end cap cover replaces a worn or broken trim piece to restore a finished look and secure an exposed edge. It keeps components aligned and helps prevent snagging or debris buildup along the opening. What it does:

• Covers and protects the exposed end of a cabinet, rail, or trim section
• Helps keep adjoining parts seated and aligned for smooth operation
• Prevents sharp or rough edges from causing snags or minor damage
• Reduces dirt and debris accumulation in the covered gap

• Unplug the appliance or disconnect power before attempting service when applicable
• Inspect the mating surface for broken tabs or debris and clean before installing
• Align the cap with mating slots or rails and press or snap into place; secure with the original fastener if required
• If tabs are damaged, replace any broken retainers to ensure a secure fit