Kenmore Range 790.46139301 (79046139301, 790 46139301) Parts

Range showing F3 or F10 error code? This safety thermostat prevents overheating by cutting power when temperatures exceed safe limits. Moderate DIY repair.

Range won't heat or overheats? This safety thermostat protects against excessive temperatures. Direct replacement part for reliable operation.

Replacement control panel for your oven. Installs on the front to house controls and display. Order a new panel if yours is cracked, damaged, or discolored.

Oven not heating or baking unevenly? This lower bake element restores proper heating for even cooking. Moderately easy DIY repair in 30-45 minutes.

Ignitor orifice assembly for gas cooktops. Connects ignitor electrode to burner. Replace if cracked, damaged, or missing for proper ignitor positioning.

Ignitor orifice assembly for gas cooktops. Mounts near the burner to position the ignitor for proper spark. Replace if cracked, damaged, or missing.

Range door gasket creates an airtight seal for efficient heating. Replace if worn, cracked, or oven loses heat. Verify fit with your model number.

Insulation panel for ovens and ranges. Installs inside the oven cavity to provide heat retention and sound dampening. Replace if torn, compressed, or missing.

Rubber or plastic bushing that cushions and supports the oven door. Replace if cracked, worn, missing, or causing door misalignment or rattling.

Insulates and cushions the oven cabinet interior. Replace if cracked, damaged, or missing to restore thermal separation and reduce condensation.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

This ignitor orifice assembly controls gas flow to the oven burner and provides the proper delivery point for ignition. It helps restore reliable ignition when the burner sparks but won't light or produces a weak flame. What it does:

• Directs gas through the correct orifice to the oven burner for ignition
• Works with the igniter to allow consistent lighting of the bake/broil burner
• Can resolve symptoms such as burner not lighting or a very small/uneven flame
• Replaces a damaged, clogged, or improperly seated orifice assembly

• One ignitor orifice assembly

• Turn off power to the appliance and shut off the gas supply before starting work
• Handle with care and avoid forcing connections; light fittings may be fragile
• After installation, check for gas leaks and proper ignition before regular use

This end cap cover replaces a worn or broken trim piece to restore a finished look and secure an exposed edge. It keeps components aligned and helps prevent snagging or debris buildup along the opening. What it does:

• Covers and protects the exposed end of a cabinet, rail, or trim section
• Helps keep adjoining parts seated and aligned for smooth operation
• Prevents sharp or rough edges from causing snags or minor damage
• Reduces dirt and debris accumulation in the covered gap

• Unplug the appliance or disconnect power before attempting service when applicable
• Inspect the mating surface for broken tabs or debris and clean before installing
• Align the cap with mating slots or rails and press or snap into place; secure with the original fastener if required
• If tabs are damaged, replace any broken retainers to ensure a secure fit