Kenmore Range 790.46763902 (79046763902, 790 46763902) Parts

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Support rod that holds the cooktop top in place. Replace this structural pin if the original is broken, bent, or missing to properly secure the top.

Replacement owner's manual for your range. Includes setup instructions, operating guidelines, and maintenance tips. Perfect when original is lost or damaged.

Control panel trim for your range. Replaces cracked, broken, or discolored trim pieces. Installs on the front console to restore appearance.

Structural frame and wheel assembly for electric ranges. Replaces damaged, bent, or broken frame components. Installs at base to support appliance mobility.

Replace your oven's support plate if it's cracked, broken, or missing. This structural component mounts inside the oven cavity to secure internal parts.

This is the bottom panel of the oven cooling fan air duct assembly, which directs airflow to cool internal components and control electronics during and after cooking. It helps prevent overheating of surrounding cabinetry and sensitive parts. Replace this piece if it is warped, cracked, or missing, which can lead to excessive heat buildup around controls or the oven exterior becoming unusually hot.

This is a metal mounting bracket used to secure an over-the-range microwave to the wall or cabinet during installation. It provides structural support and helps keep the microwave properly aligned and stable. Replace this bracket if it is bent, broken, or missing, which can cause the microwave to sit unevenly or become unsafe.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

Metal bracket that secures your range to the wall or floor to prevent tipping. Replace if bracket is bent, broken, or missing during installation.

Anti-tip warning label for electric ranges. Replaces faded, peeling, or missing safety labels on the anti-tip bracket. Ensures compliance with safety standards.

Secures the glass panel on your oven door. Replace if the bracket is cracked, bent, or missing to properly hold the glass in place and restore door integrity.