Kenmore Range 790.46892903 (79046892903, 790 46892903) Parts

Rear panel back for ovens and ranges. Replaces cracked, damaged, or missing exterior back panels. Essential structural part for cabinet integrity.

Illuminates your range oven cavity for visibility while cooking. Replace when bulb burns out or dims. Verify compatibility with your model number.

Sound dampening insulation for electric ranges. Installs inside the range cabinet to reduce noise and provide thermal protection. Replace if worn or missing.

Replaces cracked, broken, or damaged control panel trim on your range. This decorative panel covers the control area and restores a clean finish.

Replace your electric range's mounting bracket if it's bent, cracked, or broken. This metal bracket secures internal components in place during operation.

Structural mounting bracket for electric and gas ranges. Secures components in place. Replace if bent, broken, cracked, or missing to restore proper fit.

Secures your range to the wall or floor to prevent tipping hazards. Replace if missing, damaged, or when installing a new range. Essential safety bracket.

Protective guard panel for electric range control areas. Replaces cracked, broken, or missing panels. Shields controls and internal components from damage.

This bushing supports and guides a rotating shaft to reduce friction and wear, helping the appliance run quietly and smoothly. Replacing a worn bushing restores proper alignment and prevents further damage to the shaft or housing. What it does:

• Provides a low-friction bearing surface for a rotating shaft
• Keeps the shaft aligned to prevent wobble and uneven operation
• Reduces noise caused by metal-on-metal contact
• Helps prevent excessive wear that can lead to binding or failure

• Disconnect power to the appliance before starting any repair
• Inspect the shaft and surrounding housing; replace if scored or damaged
• Remove the old bushing and press or snap the new bushing into place using appropriate hand tools
• If other wear items (bearings, seals, mounts) show damage, replace them to prevent repeat failure