Kenmore Range 790.47102400 (79047102400, 790 47102400) Parts

If your burner won't light or the flame is too high or too low, this gas valve controls flow to restore proper ignition and flame adjustment on your cooktop.

Oven not heating or baking unevenly? This lower bake element restores proper heating for even cooking. Moderately easy DIY repair in 30-45 minutes.

Range door gasket creates an airtight seal for efficient heating. Replace if worn, cracked, or oven loses heat. Verify fit with your model number.

Control panel plate for gas ranges. Replaces scratched, dented, or discolored front panels. Installs on the top control area to restore appearance.

Insulation panel for ovens and ranges. Installs inside the oven cavity to provide heat retention and sound dampening. Replace if torn, compressed, or missing.

Rubber or plastic bushing that cushions and supports the oven door. Replace if cracked, worn, missing, or causing door misalignment or rattling.

Insulates and cushions the oven cabinet interior. Replace if cracked, damaged, or missing to restore thermal separation and reduce condensation.

Anti-tip warning label for electric ranges. Replaces faded, peeling, or missing safety labels on the anti-tip bracket. Ensures compliance with safety standards.

This lower front trim, or skirt, replaces the worn or damaged toe-kick panel at the base of the appliance to restore appearance and help protect internal components from debris. It fits the cabinet front and provides a finished look. What it does:

• Covers and protects the appliance's lower front area, shielding components and wiring from dust and debris
• Helps keep floor-level drafts out and maintains a finished cabinet appearance
• Restores a secure fit if the original skirt is cracked, bent, or loose
• Prevents small objects from rolling under the appliance and into service areas

• Disconnect power to the appliance before beginning work to avoid electrical hazards
• Removal typically requires lifting or unsnapping the existing skirt and releasing a few mounting clips or screws
• Handle edges carefully; wear gloves to avoid cuts from sheet metal or sharp plastic tabs
• If clips are damaged, replace with compatible fasteners for a secure fit

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening