Kenmore Wall Oven 790.48803100 (79048803100, 790 48803100) Parts

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Restores proper rack positioning and support for level, stable cookware. Replace when racks are bent, warped, or slide poorly. Confirm fit with your model.

Interior panel component for microwave oven doors. Replaces cracked, dented, or broken inner door panels. Essential for maintaining door integrity.

This is a small plastic lever located on the right side of the microwave door assembly that actuates the door interlock safety switch. It ensures the microwave detects when the door is properly closed before allowing operation. Replace this lever if your microwave won't start, runs with the door open, or if the lever is cracked or broken.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Secures and routes wiring cables inside your range or oven. Replace this retainer bracket if it's cracked, broken, or missing to properly support cables.

Metal support bracket that secures and stabilizes range components. Replaces broken, bent, or missing brackets to restore proper panel alignment.

Sound dampening insulation for wall ovens. Replaces worn, damaged, or missing insulation that reduces noise and heat transfer during operation.

This is a thermal cut-out safety device that shuts off the microwave when internal temperatures exceed safe operating limits. It functions as a protective thermostat to prevent overheating and potential damage to the appliance. Replace this part if the microwave shuts off unexpectedly during use, fails to power on, or if the unit is overheating.

Microwave not heating? This high voltage transformer powers the magnetron to generate heat. Critical component requiring careful installation.

Microwave not heating? A failed transformer prevents the magnetron from generating heat. This high-voltage component requires electrical expertise to install.

Replacement front cabinet trim frame for microwaves. Restores finished look when original is cracked, warped, or broken. Secures control area alignment.

This is a spark ignition switch with an attached wire harness that connects to the ignition system on a gas range or wall oven. It sends an electrical signal to the spark module to ignite the gas burner when the control knob is turned. Replace this assembly if burners fail to ignite, spark intermittently, or if the wiring is damaged or burned.

Spring component for microwave ovens. Installs internally to provide tension or support. Replace if spring is broken, stretched, or missing for proper function.