Kenmore Range 790.70260403 (79070260403, 790 70260403) Parts

This is a mounting screw used to secure the thermostat or other internal components within the range or oven. It ensures the thermostat stays firmly in place for accurate temperature regulation. Replace this screw if it is stripped, corroded, or missing, which can cause the thermostat to shift and lead to inconsistent heating.

Operating instructions and care guide manual for your range. Replace lost or damaged documentation to ensure proper use and maintenance of your appliance.

Side panel for electric and gas ranges. Replaces damaged, cracked, or missing exterior panels. Installs on the body side to restore appearance.

Replace your gas range flue gasket to seal the flue opening and prevent heat loss. Install when worn, cracked, or damaged. Confirm fit with model number.

Black handle for range storage drawer. Replaces cracked, broken, or missing drawer handles. Mounts to front of warming or storage drawer for opening.

This channel burner support is a stamped support bracket designed to hold and align the range burner channel and related components so burners sit correctly. It helps restore proper fit and stable burner operation. What it does:

• Secures the burner channel and keeps burners aligned for consistent heating
• Prevents wobbling or misalignment of the burner assembly during use
• Helps maintain correct spacing between burner components and gas valve/manifold
• Commonly replaced when the original support is bent, cracked, or damaged

• One channel burner support bracket

• Designed to mount with existing fasteners; inspect screws or clips and replace if worn
• Turn off power and gas supply (for gas ranges) before servicing; follow appliance safety procedures
• Handle sharp edges carefully; wear gloves to avoid cuts

Replace the low broil liner panel in your gas range oven cavity. This trim panel covers the lower broil area and may need replacement if cracked or damaged.

Mounting bracket that secures the backguard panel to your range. Replace if bent, broken, or missing to ensure proper backguard installation.