Kenmore Range 790.74503990 (79074503990, 790 74503990) Parts

This aluminum-faced door insulation panel replaces the factory insulation inside a refrigerator or freezer door to help restore proper door thermal barrier and reduce air leakage. It fits behind the inner door panel and helps the appliance maintain set temperatures. What it does:

• Replaces damaged or degraded door insulation to improve the door's thermal barrier
• Helps reduce warm spots and excess frost that can result from poor door insulation
• Can help normalize compressor run time caused by air leakage around the door cavity
• Restores the door's internal padding and support for the inner door panel

• Always unplug the appliance before starting; remove food and secure shelves
• Remove the inner door panel or liner to access and replace the insulation
• Handle insulation carefully; avoid compressing or puncturing the panel during installation
• Reassemble door components in reverse order and verify a proper seal before use

Mounting plate that secures the power cord set to the back of your range. Replace if the original plate is cracked, broken, or missing during installation.

This lower oven heat shield protects the range's under-floor components by deflecting and dispersing high heat. It helps prevent damage to wiring, insulation and nearby panels for safer, more reliable oven operation. What it does:

• Deflects and distributes heat away from the oven floor and cabinet cavities
• Protects wiring, insulation and nearby components from excessive heat exposure
• Helps prevent warped panels, scorched insulation or premature component failure
• Restores proper heat routing when the original shield is damaged, bent or missing

• One lower heat shield

• Disconnect power (and gas supply for gas ranges) before starting any service
• Handle carefully; edges may be sharp—wear gloves and eye protection
• May require removal of the oven floor or lower access panel and fastening hardware

Insulation blanket that wraps around the oven cavity to retain heat and reduce exterior surface temperatures. Replace if torn, compressed, or missing.

This manifold routes fluid or gas between the appliance's control valve and downstream components, restoring proper flow and operation. A direct-fit replacement that returns the system to manufacturer-intended routing and sealing. What it does:

• Channels fluid or gas from the control valve to the appliance's supply lines or burners
• Restores proper pressure and distribution for normal operation
• Can stop leaks or irregular flow caused by a cracked or damaged manifold
• Helps resolve symptoms such as poor performance, inconsistent operation, or visible leakage near the manifold area

• Always disconnect power and shut off gas or water supply before beginning work
• Inspect and replace any damaged gaskets, seals, or mounting hardware during installation
• Use proper torque on fittings to ensure leak-free connections; check for leaks after installation