Kenmore Range 790.74503992 (79074503992, 790 74503992) Parts

This is a seal gasket that fits around the burner drip pan on a cooktop or range. It creates a tight seal between the drip pan and the cooktop surface to prevent spills and debris from falling beneath the burner area. Replace this gasket if it is cracked, hardened, or no longer sealing properly, which can allow grease and liquids to leak below the cooktop.

Secures cooktop surface elements to your range for stable contact and even heating. Replace if bent or worn to restore proper element positioning.

Hex washer head ,10-32 x 0.375. Ground

This is the rear panel that mounts on the back of a freestanding range, enclosing and protecting the internal wiring, insulation, and components behind the oven cavity. It helps maintain proper airflow and shields electrical connections from damage. Replace this panel if it is dented, rusted through, or missing, which can compromise insulation efficiency and expose internal components.

Decorative trim panel that covers the base of your range. Replace this toe plate if it's cracked, scratched, or missing to restore a finished look.

This hinge pin spacer helps position the refrigerator door hinge pin for proper door alignment and smooth operation. It replaces a worn or missing spacer to restore correct hinge spacing and reduce door binding. What it does:

• Holds the hinge pin at the correct height and offset for the upper or lower door hinge
• Helps prevent door sag, misalignment, and uneven sealing
• Reduces metal-on-metal contact and rubbing that can cause noise or wear
• Works at either the upper or lower hinge location as specified for your model

• One hinge pin spacer

• Disconnect power to the appliance or unplug the refrigerator before starting any repair
• Support the door while removing hinge hardware to prevent the door from falling
• Reuse existing hinge pin and hardware unless damaged; replace any worn fasteners

Right-hand end cap bracket for ranges. Secures and protects the end panel. Replace if cracked, broken, or missing to restore structural integrity.

Slide bracket that supports and guides oven racks smoothly in and out. Replace if cracked, bent, or missing to restore proper rack movement in your range.

Burner tube for cooktop gas burners. Connects gas valve to burner head. Replace if cracked, corroded, or damaged to restore proper gas flow and fit.

Replace a cracked, corroded, or damaged oven burner tube that routes gas from the manifold to the burner ports. Restores proper gas flow and even heat.

Burner tube for gas ranges. Delivers gas from the valve to the burner head. Replace if cracked, corroded, or damaged to restore proper gas flow.

This burner tube connects the gas valve to the burner on your range. Replace if tube is cracked, corroded, blocked, or shows signs of wear or damage.

Reinforces and supports oven door glass panels. Replace if original stiffener is bent, cracked, or missing to properly secure glass in the door frame.

Burner support shim for ranges. Installs between burner assembly and cooktop to maintain proper spacing. Replace if worn, cracked, or missing.