Kenmore Range 790.78639601 (79078639601, 790 78639601) Parts

Replace your gas range flue gasket to seal the flue opening and prevent heat loss. Install when worn, cracked, or damaged. Confirm fit with model number.

Replacement mounting screw for range power and control boards. Secures electrical board connections. Needed when original screw is missing or damaged.

Black exterior door trim for gas ranges. Covers and protects the outer edge of the door. Replace if cracked, chipped, worn, or missing to restore appearance.

Protective wire shield for gas range safety valve. Replaces cracked, damaged, or missing guards. Installs over valve wiring for safety and protection.

Replace your gas range shield if the original is damaged, cracked, or missing. This protective guard installs to shield internal components from heat and debris.

Replace a cracked, damaged, or missing heat shield on your gas range. This protective guard installs to prevent heat damage to internal components.

Rear panel for gas ranges. Installs on the back of the unit to enclose internal components. Replace if cracked, damaged, or missing to restore appearance.

Shield guard for gas ranges. Protects internal components from heat and debris. Replace if cracked, damaged, or missing to maintain proper coverage.

This wiring harness connects internal components to restore electrical and signal continuity in your appliance. It replaces a damaged or worn harness to help regain reliable operation and safe power distribution. What it does:

• Transfers power and control signals between modules and components
• Replaces frayed, cut, or brittle wires that cause intermittent power or function loss
• Helps stop issues like controls that won't respond, motors that don't run, or lights that fail to power
• Provides factory-style connectors to maintain correct component mating and polarity

• Disconnect power to the appliance before starting any repair
• Route harness clear of sharp edges and moving parts; secure with existing clips or ties
• If you see damaged connectors or corrosion at mating terminals, clean or replace those parts as needed