Kenmore Range 790.79013100 (79079013100, 790 79013100) Parts

This sealed gas burner provides the primary cooking flame for compatible ranges, restoring even, reliable heat for stovetop cooking. Replace a worn or damaged burner to regain proper ignition and consistent simmer-to-boil performance. What it does

• Produces a controlled 14K BTU cooking flame for standard burner heating (per OEM listing)
• Replaces cracked, warped, or corroded burner surfaces that cause uneven cooking
• Helps address ignition failures, weak or irregular flames, and gas flow inconsistencies
• Fits into the burner bowl and works with factory burner caps and grates to seal heat and prevent spills

• One sealed burner (14K) as shown

• Turn off and disconnect the appliance from gas and electricity before servicing
• Handle carefully to avoid bending the burner tube or damaging the mounting tabs
• Use basic hand tools; confirm correct orifice and alignment when reinstalling

This black burner skirt fits around a 5K simmer burner ring to restore proper appearance and support the cooktop surface. Replaces cracked or damaged skirts to keep the burner area sealed and looking finished. What it does:

• Provides the decorative and protective trim around a 5K (5000 BTU) simmer burner
• Helps keep spills and debris from entering the burner cavity
• Restores even contact and alignment for the burner assembly
• Commonly replaced when the skirt is cracked, warped, or missing

• One black burner skirt (5K)

• Turn off and disconnect power and gas supply and allow all surfaces to cool before servicing
• Remove burner caps and grates per your model's service instructions to access the skirt
• Handle carefully to avoid bending or cracking; hand tools usually sufficient

This burner seal fits around a cooktop burner to help keep spills and debris out of the burner housing and provide a stable, centered burner location for consistent heating. It restores a flush seal between the burner and the cooktop surface. What it does:

• Forms a protective gasket around the burner to block food, grease and liquids from entering the cooktop cavity
• Cushions and centers the burner, reducing wobble and promoting even element-to-surface contact
• Helps reduce smoke or odors caused by spills burning on exposed internal surfaces
• Restores proper fit after a cracked, torn or missing seal

• One burner seal

• Disconnect power to the appliance before servicing; if the range is gas, shut off the gas supply
• Remove the burner or lift the cooktop per your model's service instructions to access the seal area
• Clean and dry the mounting surface thoroughly before installing the new seal
• Press the seal into place; do not stretch excessively or use solvents/adhesives unless your model's instructions specify

This control panel overlay replaces a worn or damaged console face to restore button labeling and the appliance's appearance. It provides the front graphics and surface where buttons are read and pressed. What it does

• Restores legible button labels and on-panel graphics for the control console
• Replaces scratched, faded, or peeled overlay surfaces that affect appearance
• Helps prevent dirt and moisture from contacting the underlying electronics
• Useful when buttons or icons are worn, making controls hard to read

• Disconnect power to the appliance before beginning any work
• Remove any retaining screws or clips holding the old overlay; save and reuse hardware only if undamaged
• Align the overlay carefully with mounting tabs and connectors; avoid bending or creasing the part
• If the overlay attaches to a keypad or electronic assembly, handle the electronics gently and avoid touching circuit contacts

Size: 8-18ab x 0.5 inch.