Kenmore Range 790.79112202 (79079112202, 790 79112202) Parts

This clip is a small mounting retainer used to secure panels, trim, or wiring inside the refrigerator. It restores proper fit and reduces rattling or loose parts for a quieter, safer appliance. What it does

• Holds panels, trim pieces, or wiring harnesses in place to prevent sagging or separation
• Stops vibrations and rattling caused by loose components
• Prevents wiring from rubbing or catching on moving parts
• Helps maintain correct alignment of removable trim and access panels

• Inspect the mating surfaces for damage; replace any broken mating tabs before installing the clip
• Push the clip into the mounting hole until it snaps securely; verify the retained part is firmly seated
• Disconnect power to the appliance before working near electrical components
• Use hand tools only and avoid force that could break adjacent plastic parts

Fix burners that won't light with this range igniter switch wiring harness. Restores spark ignition when push-to-turn knobs fail to ignite gas burners.

Burner cap for gas cooktops. Sits atop the burner head to distribute flame evenly. Replace if cracked, chipped, discolored, or missing for proper burner operation.

This main wiring harness routes power and signals between your refrigerator's control components, helping the unit start and operate safely. Replaces a worn or damaged harness to restore reliable electrical connections. What it does:

• Provides power and signal pathways between control board, compressor, fan, lights and other components
• Restores lost or intermittent power caused by cracked wires, broken terminals or corroded connections
• Prevents short circuits and erratic operation when connectors and insulation are intact
• Helps resolve symptoms like no power to components, intermittent runs, or functional failures tied to wiring

• One main wiring harness assembly

• Disconnect power at the breaker or unplug the appliance before servicing
• Access may require removing interior panels or rear cover; keep track of fasteners and connector locations
• Compare connector shapes and wire colors to the old harness before installing; route and secure harness away from heat and moving parts