Kenmore Range 790.90914400 (79090914400, 790 90914400) Parts

0.6 fluid ounces

Color: Black

This door trim kit replaces the perimeter trim on the appliance door to restore a clean, factory finish. It covers and protects the door edges when the original trim is cracked, warped, or missing.

• Frames the door perimeter for a finished, uniform appearance
• Helps cover raw edges to prevent snags and rattling
• Replaces cracked, warped, or missing trim pieces
• Common signs include loose or missing trim, cosmetic damage, and gaps along the door edge

• Disconnect power (and gas, if applicable) and allow the appliance to cool before service
• Support the door; remove it if your service information recommends
• Carefully remove old trim; handle glass and sharp edges with cut-resistant gloves
• Align and secure the new trim; avoid overtightening fasteners and verify smooth door operation

This molded cabinet liner insulation reduces heat transfer around the refrigerator cavity to help maintain steady temperatures and improve cooling efficiency. Designed to replace worn or damaged insulation that can allow frost buildup or increased run time. What it does

• Fills the airspace between the outer cabinet and inner liner to slow heat gain
• Helps the cooling system maintain consistent internal temperatures
• Can reduce frost accumulation caused by damaged or missing insulation
• Restores the original thermal barrier after repair or after removing interior components

• One pre-formed cabinet liner insulation piece

• Disconnect power to the appliance before starting any repair
• Remove shelves, panels, and fasteners as needed to access the insulation cavity
• Handle gently to avoid compressing or tearing the material; fit into existing channels or adhesive points
• If adhesive is required, use manufacturer-recommended high-temperature adhesive or fasteners

Right Hand Endcap - Color: Black

This control panel is the front console assembly that houses the user controls and display, restoring proper button access and visible status indicators so you can select cycles and monitor operation. What it does:

• Provides the tactile buttons and display area for user input and cycle selection
• Protects and aligns the underlying electronic controls and switches
• Restores readable status lights and labels that indicate selected settings
• Commonly replaced when buttons are unresponsive, cracked, or cosmetic damage prevents normal use

• One control panel/console assembly

• Verify power is disconnected before starting any repair to avoid shock or damage
• Replacement typically requires removing the outer cabinet or control trim; keep hardware organized
• Inspect underlying switches and wiring during installation; replace any damaged fasteners or clips
• Recheck connector seating and wiring harness integrity after installation

Size: 8-18ab x 0.5 inch.