Kenmore Range 790.90924401 (79090924401, 790 90924401) Parts

Side panel for electric and gas ranges. Replaces damaged, cracked, or missing exterior panels. Installs on the body side to restore appearance.

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This left-side bisque end cap finishes and protects the refrigerator door edge, restoring a clean appearance and helping keep the door trim secure. It's a direct-fit replacement for worn, cracked, or broken end caps. What it does:

• Covers and protects the outer edge of the refrigerator door trim on the left side
• Restores a finished appearance when original trim is cracked, broken, or missing
• Helps keep door components and seals neatly aligned and supported
• Compatible with factory door trim to maintain proper fit and gap

• Read the appliance manual before beginning; unplug the appliance or turn off power to the unit when instructed by the manufacturer
• Remove any damaged trim carefully to avoid scratching the door finish
• Align the end cap with the door edge and snap or fasten per factory attachment points; use gentle pressure to avoid cracking
• If clips or screws are required, reuse original hardware or replace with OEM-specified fasteners

Replace a cracked or missing right-hand shield end cap on your range. This protective trim piece covers the end of the range shield for a complete finish.

Left-hand end cap shield for range oven doors. Replaces cracked, broken, or missing caps that protect the door edge. Installs on the left side of the door.

This is a printed instruction manual covering the installation procedures for a freestanding or slide-in range. It includes details on electrical or gas connections, leveling, anti-tip bracket installation, and initial setup. You may need this document if the original instructions were lost and you are reinstalling or relocating the range.

Replacement control console panel for electric ranges. Restores front trim around controls and display. Replaces cracked, faded, or bent panels.

Replacement shield for your range. Protects internal components from heat and damage. Order a new one if yours is cracked, bent, or missing.

Factory schematic label showing your range's electrical circuits and component connections. Replace if label is faded, peeling, or missing.