Kenmore Range 790.91044403 (79091044403, 790 91044403) Parts

Size: 8-18ab x 0.5 inch.

Replaces cracked, dented, or discolored side panel trim on your range. This exterior body panel restores the clean finished look of your appliance.

Secures cooktop coil element to range for stable contact and safe heating. Replace if element is loose or wobbles. Confirm fit with your model number.

Replacement back panel for your electric range. Covers the rear of the range chassis. Order a new panel if yours is cracked, damaged, or missing.

Outer door panel for gas ranges. Installs on the front of the oven door to restore appearance. Replace if cracked, dented, discolored, or worn.

Service data sheet for ranges. Technical reference guide with wiring diagrams, specifications, and troubleshooting info. Replace missing or damaged sheets.

Heat shield for electric and gas ranges. Mounts inside the range to protect components from heat damage. Replace if cracked, warped, or missing.

Replace your range's internal wiring harness if damaged, frayed, or showing exposed wires. Connects electrical components inside the control assembly.

Side panel for electric and gas ranges. Replaces damaged, cracked, or missing exterior panels. Installs on the body side to restore appearance.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This left-side bisque end cap finishes and protects the refrigerator door edge, restoring a clean appearance and helping keep the door trim secure. It's a direct-fit replacement for worn, cracked, or broken end caps. What it does:

• Covers and protects the outer edge of the refrigerator door trim on the left side
• Restores a finished appearance when original trim is cracked, broken, or missing
• Helps keep door components and seals neatly aligned and supported
• Compatible with factory door trim to maintain proper fit and gap

• Read the appliance manual before beginning; unplug the appliance or turn off power to the unit when instructed by the manufacturer
• Remove any damaged trim carefully to avoid scratching the door finish
• Align the end cap with the door edge and snap or fasten per factory attachment points; use gentle pressure to avoid cracking
• If clips or screws are required, reuse original hardware or replace with OEM-specified fasteners