Kenmore Range 790.91419010 (79091419010, 790 91419010) Parts

This 100W radiant element replaces a failed warming element to restore gentle, even heat in the appliance's warmer/drawer. It delivers low-profile radiant heat for keeping food warm between cooking and serving. What it does:

• Radiates low-level heat to maintain food temperature in the warmer or drawer
• Replaces a broken or non-heating warmer element
• Common symptom: warmer drawer not holding temperature or not heating
• Works as the heating element that sits under the warming surface to provide consistent warmth

• Disconnect power to the appliance before attempting service
• Inspect mounting and wiring; replace any damaged connectors or mounting hardware as needed
• Handle the element carefully to avoid bending or damaging the heating surface

Control panel trim for electric and gas ranges. Replaces cracked, faded, or damaged panel trim. Installs on the front control area to restore appearance.

Replacement mounting screw for range power and control boards. Secures electrical board connections. Needed when original screw is missing or damaged.

Protective cover that shields the range door hinge assembly from debris and damage. Replace if cracked, broken, or missing to restore a clean finished look.

Mounting bracket that secures the range cabinet and internal components for proper alignment. Replace if cracked, bent, or broken to restore stability.

Control panel trim for electric ranges. Replaces cracked, broken, or discolored trim pieces. Installs on the front control area to restore appearance.

Replace a cracked, broken, or missing shield on your range. This protective guard component installs to safeguard internal parts from damage or wear.

Size: 8-18ab x 0.5 inch.

Inner glass panel for range oven doors. Replace this part if your existing glass is cracked, shattered, or broken. Installs inside the door frame.

Replacement back panel for your electric range. Covers the rear of the range chassis. Order a new panel if yours is cracked, damaged, or missing.

Shield protects the wire harness near the vent tube in your range. Replace if cracked, damaged, or missing to prevent wire exposure and ensure safe operation.

Replace your range's heat shield if it's cracked, warped, or missing. This protective barrier installs between heating elements and components.

Mounting bracket for electric and gas ranges. Secures components in place. Replace if bent, cracked, or broken to restore proper fitment and stability.