Kenmore Range 790.94213400 (79094213400, 790 94213400) Parts

Replace cracked, broken, or discolored oven door glass panel. Installs between inner and outer door frames. Needed when glass is damaged or worn.

Covers the gap at the range door filler area for a finished look and keeps debris out. Replace when cracked, broken, or missing to restore appearance.

Oven vent tube for your range. Channels hot air from the oven cavity to the exhaust. Replace if cracked, damaged, or missing for proper ventilation.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

Mounting bracket that secures the heating element in your range. Replace this bracket if it's bent, broken, cracked, or missing to properly support the element.

Anti-tip warning label for electric ranges. Replaces faded, peeling, or missing safety labels on the anti-tip bracket. Ensures compliance with safety standards.

This is a printed instruction manual covering the installation procedures for a freestanding or slide-in range. It includes details on electrical or gas connections, leveling, anti-tip bracket installation, and initial setup. You may need this document if the original instructions were lost and you are reinstalling or relocating the range.

Replacement control console panel for electric ranges. Restores front trim around controls and display. Replaces cracked, faded, or bent panels.

This shield is a replacement protective panel that covers and protects internal appliance components from debris and heat, helping maintain safe operation and appliance appearance. What it does:

• Covers exposed internal components to reduce debris buildup and prevent accidental contact
• Helps direct airflow or heat away from sensitive parts
• Replaces a cracked, bent, or missing shield that may cause vibration or scraping noises
• Restores a finished appearance to the appliance where the original shield was damaged

• One replacement shield

• Disconnect power (unplug or switch off breaker) before service to avoid shock or injury
• Typical installation requires removing nearby panels and fastening the shield with screws or clips—retain all hardware for reassembly
• Handle carefully to avoid sharp edges; wear gloves and eye protection

Control panel trim for electric ranges. Covers and protects the control board area. Replace if cracked, chipped, discolored, or broken. Restores appearance.