Kenmore Range 790.9421340A (7909421340A, 790 9421340A) Parts

Secures cooktop coil element to range for stable contact and safe heating. Replace if element is loose or wobbles. Confirm fit with your model number.

Secures your range warmer drawer in place. Replace if drawer slides open, won't stay closed, or clip is broken. Verify fit with your model number.

Black push button for electric range control panels. Restores appearance when original button is cracked, broken, or missing. Installs on front panel.

If your range burner won't heat, stays on high, or cycles incorrectly, the infinite switch likely failed. This direct-fit part restores precise heat control.

Insulation blanket that installs inside your range oven cavity for heat retention and sound dampening. Replace if torn, compressed, or missing.

Covers the gap at the range door filler area for a finished look and keeps debris out. Replace when cracked, broken, or missing to restore appearance.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

Mounting bracket that secures the heating element in your range. Replace this bracket if it's bent, broken, cracked, or missing to properly support the element.

Owner's manual and care guide for your electric range. Replace lost or damaged instructions to access operating procedures, maintenance tips, and safety information.

Replacement control console panel for electric ranges. Restores front trim around controls and display. Replaces cracked, faded, or bent panels.

This shield is a replacement protective panel that covers and protects internal appliance components from debris and heat, helping maintain safe operation and appliance appearance. What it does:

• Covers exposed internal components to reduce debris buildup and prevent accidental contact
• Helps direct airflow or heat away from sensitive parts
• Replaces a cracked, bent, or missing shield that may cause vibration or scraping noises
• Restores a finished appearance to the appliance where the original shield was damaged

• One replacement shield

• Disconnect power (unplug or switch off breaker) before service to avoid shock or injury
• Typical installation requires removing nearby panels and fastening the shield with screws or clips—retain all hardware for reassembly
• Handle carefully to avoid sharp edges; wear gloves and eye protection