Kenmore Range 790.94444700 (79094444700, 790 94444700) Parts

Shield protects the wire harness near the vent tube in your range. Replace if cracked, damaged, or missing to prevent wire exposure and ensure safe operation.

Side panel for electric and gas ranges. Replaces damaged, cracked, or missing exterior panels. Installs on the body side to restore appearance.

Insulation blanket that installs inside your range oven cavity for heat retention and sound dampening. Replace if torn, compressed, or missing.

Replace your range's heat shield if it's cracked, warped, or missing. This protective barrier installs between heating elements and components.

Insulation pad for electric ranges that reduces noise and retains heat. Replace if worn, torn, compressed, or missing to restore proper sound dampening.

Replace the channel trim on your range door when it becomes cracked, broken, or damaged. This structural component installs along the door edge for a secure fit.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

Mounting bracket that secures the heating element in your range. Replace this bracket if it's bent, broken, cracked, or missing to properly support the element.

Replacement control console panel for electric ranges. Restores front trim around controls and display. Replaces cracked, faded, or bent panels.

This shield is a replacement protective panel that covers and protects internal appliance components from debris and heat, helping maintain safe operation and appliance appearance. What it does:

• Covers exposed internal components to reduce debris buildup and prevent accidental contact
• Helps direct airflow or heat away from sensitive parts
• Replaces a cracked, bent, or missing shield that may cause vibration or scraping noises
• Restores a finished appearance to the appliance where the original shield was damaged

• One replacement shield

• Disconnect power (unplug or switch off breaker) before service to avoid shock or injury
• Typical installation requires removing nearby panels and fastening the shield with screws or clips—retain all hardware for reassembly
• Handle carefully to avoid sharp edges; wear gloves and eye protection