Kenmore Range 790.96544601 (79096544601, 790 96544601) Parts

Insulation blanket that installs inside your range oven cavity for heat retention and sound dampening. Replace if torn, compressed, or missing.

Replace your range's heat shield if it's cracked, warped, or missing. This protective barrier installs between heating elements and components.

Replace the channel trim on your range door when it becomes cracked, broken, or damaged. This structural component installs along the door edge for a secure fit.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

Replacement control console panel for electric ranges. Restores front trim around controls and display. Replaces cracked, faded, or bent panels.

This is a bisque-colored left-side support bracket that mounts to the backguard area of the range. It provides structural support for the shelf or trim along the back of the cooktop. Replace this bracket if it is cracked, broken, or missing, which can cause the backguard trim or shelf to sit unevenly or come loose.

This service tech sheet is the factory-issued reference that provides the appliance's wiring diagram, component locations, and service specifications to help diagnose and repair issues more quickly and accurately. What it does:

• Shows wiring diagrams and connector details for accurate electrical troubleshooting
• Lists component locations and reference spec values for diagnostic checks
• Provides control and sensor identification to isolate faults (no power, intermittent operation, or control errors)
• Helps correct replacement parts and harness routing during repair

• Not an installation manual; review before starting repairs
• Always disconnect power and, if applicable, water before inspecting or servicing
• Use as a reference during diagnostics; keep with unit for future service
• Handle document carefully to avoid tearing or smudging printed diagrams

Replace your cracked or broken range glass main top. This glass cooktop surface installs over the burner assembly. Essential when the original is damaged.

Replaces the metal panel at the base of your oven interior. Installs on the oven floor. Needed when original is warped, rusted, or damaged by foil.