Kenmore Range 791.7899082 (7917899082, 791 7899082) Parts

This glass retainer wire secures the oven door glass so it stays in place during use, helping keep the door sealed and preventing rattling or a loose inner panel. It's a direct-fit replacement for the factory retainer. What it does:

• Holds the inner/outer oven door glass panels in the door frame to prevent movement
• Keeps the glass properly aligned to help maintain door sealing and stable operation
• Stops rattling or vibration caused by a loose glass panel
• Commonly replaced when the original retainer is bent, broken, or missing

• One glass retainer wire

• Disconnect power to the appliance before servicing and work only on a cool door
• Handle glass panels carefully to avoid breakage and injury; use gloves and eye protection
• You may need to remove the oven door or inner door panel to access the retainer; follow OEM instructions

A single #8A x 1/2" screw used to fasten trim, panels, and internal components on compatible appliances. Small but essential, it restores secure mounting and stops loose parts from rattling or shifting. What it does:

• Secures panels, brackets, and trim to the appliance chassis
• Replaces missing, stripped, or corroded screws that cause rattling or loose fittings
• Provides proper thread engagement for consistent, reliable fastening
• Helps maintain alignment of components that depend on a correctly sized screw

• Disconnect power to the appliance before working on any electrical or mechanical components
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and avoid overtightening; snug is usually sufficient for sheet-metal fastening
• Keep removed fasteners in a small container to avoid loss during reassembly

A single replacement mounting screw that secures the transformer to the appliance chassis. Keeps the transformer firmly attached to help maintain reliable power to the controls and reduce vibration-related noise. What it does:

• Secures the control/door transformer to the appliance chassis or bracket.
• Prevents transformer movement that can cause rattling or vibration noise.
• Helps maintain proper electrical connections by keeping the transformer stable.
• A missing or loose screw can lead to intermittent power to controls or unusual sounds.

• Always disconnect power to the appliance before starting work.
• Use the correct screwdriver to avoid stripping the head; tighten snugly but do not overtighten.
• Keep original hardware and screw length and thread match before installing.
• If the transformer or wiring looks damaged, replace or inspect components as needed before reassembly.

This flat washer is a replacement fastener spacer that helps secure and evenly distribute load on screws or bolts in your appliance. Installing the correct washer restores proper fastening and prevents metal-on-metal wear. What it does:

• Provides an even bearing surface under a screw or nut to secure assemblies
• Helps maintain proper alignment of parts and prevents loosening from vibration
• Reduces wear and protects mating surfaces from damage
• Commonly used where a thin, flat spacer is required during reassembly

• One flat washer (quantity: 1)

• Turn off and unplug the appliance before starting any repair
• Replace only the washer(s) that match the original location and orientation
• Hand-start fasteners to avoid cross-threading; tighten to OEM torque if specified
• If the original washer shows damage or corrosion, replace it with this new part