Kenmore Refrigerator 795.71053012 (79571053012, 795 71053012) Parts

This pipe holder is a small plastic clip that secures tubing and small pipes inside the appliance, helping keep lines organized and preventing rubbing or disconnection. It restores proper routing and reduces vibration-related noises. What it does:

• Holds and secures water, drain, or refrigerant tubing to prevent sagging and chafing
• Keeps lines routed away from moving parts to reduce wear and noise
• Helps maintain proper tube alignment to avoid strain on fittings
• Commonly replaced when the original clip is cracked, broken, or missing

• Disconnect power and water before working on the appliance
• Inspect surrounding tubing and fittings for damage when replacing the clip
• Typically installs as a push-fit or snap-on clip; use gentle pressure and avoid forcing
• Replace broken or brittle clips to prevent tubing damage or leaks

Fixes inconsistent cooling between compartments. This damper assembly controls airflow to restore proper temperature balance in your refrigerator.

Left-hand rail end cap for refrigerator drawer slides. Replaces cracked, broken, or missing caps on drawer rail ends. Secures and protects rail edges.

A replacement cover motor that powers the refrigerator's dispenser cover, allowing the door to open and close so you can access ice and water. Replaces a worn or failed motor to restore normal dispenser cover operation. What it does:

• Drives the dispenser cover mechanism so the cover opens when dispensing and closes when idle
• Helps keep the dispenser sealed to reduce drafts and prevent pests or debris from entering
• Stops or fails to move when worn, causing a stuck, slow, or noisy dispenser cover
• Works with the dispenser linkage and gears to coordinate cover motion with user controls

What's included:

• One cover motor

Install notes:

• Disconnect power to the appliance before beginning any repair
• Remove dispenser trim and access panel per your model's service instructions to reach the motor
• Handle gears and linkage carefully; ensure proper alignment during reassembly and test cover operation before finishing

Fixes unresponsive control panel, blank display, or non-working touchpad on your refrigerator. This display power control board restores interface functionality.

Right-side rail cap for refrigerator drawer slides. Replaces cracked, broken, or missing caps that cover the drawer rail ends for a finished look.

Replacement mounting screw for refrigerator panels, trim, and components. Secures loose or missing fasteners to reduce vibration and keep parts in place.

This is a protective case assembly that houses the printed circuit board (PCB) for the refrigerator's ice dispenser or display panel. It encloses and shields the electronic control board from moisture and physical damage. Replace this assembly if the housing is cracked, melted, or damaged, or if you need to access or replace the control board inside.

Replaces a worn, cracked, or broken refrigerator door hinge assembly. Installs on the door frame to restore proper alignment and smooth operation.

Replacement door hinge assembly for your refrigerator. Installs on the cabinet to support the door. Replace if cracked, bent, or worn for proper alignment.

Small protective cap covers component connections or openings in your refrigerator. Replace when cracked, missing, or worn to protect against dirt and moisture.