Kenmore Refrigerator 795.71059010 (79571059010, 795 71059010) Parts

90-degree elbow connector for 1/4" refrigerator water lines. Replaces cracked, leaking, or broken tube fittings between filter and dispenser.

This is the condenser fan motor assembly located near the compressor at the back or bottom of the refrigerator. It draws air across the condenser coils to dissipate heat and keep the refrigeration system running efficiently. Replace this motor if the refrigerator is running warm, the compressor is overheating, or you no longer hear the fan running when the compressor is on.

Restores a tight seal around your refrigerator door to keep cold air in and warm air out. Replace when worn, torn, or cracked to maintain efficiency.

Supports and guides refrigerator drawers along their track for smooth sliding. Replace if cracked, broken, or worn to restore proper drawer alignment.

Fix frost buildup and uneven cooling in your refrigerator with this evaporator defrost heater. Melts ice from coils during defrost cycles. Moderate repair.

Secures components in your refrigerator assembly, reducing vibration and keeping parts properly seated. Replace when damaged or missing to restore snug fit. Verify model compatibility before ordering.

Fix error codes and cooling failures with this refrigerator main control board. Manages cycles, timing, and sensors. DIY-friendly repair solution.

Drawer slide rail guide assembly for refrigerator shelves and bins. Replaces worn, broken, or damaged rails that cause sticking or misalignment.

Leveling leg for refrigerators. Installs at bottom corner to elevate and stabilize the appliance. Replace if broken, compressed, or no longer secure.

Plastic trim cap that snaps over exposed fasteners and mounting posts on your refrigerator. Replace if cracked, broken, missing, or discolored.

Secures and pivots the ice bank door for smooth opening and proper sealing. Replace if door sags, won't close, or ice dispenser misaligns. Confirm fit.

Refrigerator door spring that provides tension for smooth door operation. Replace if spring is broken, stretched, worn, or missing for proper closure.

Left-hand rail end cap for refrigerator drawer slides. Replaces cracked, broken, or missing caps on drawer rail ends. Secures and protects rail edges.

This is a rear end cap that attaches to the end of the refrigerator door handle. It provides a finished appearance and secures the handle in place. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or look incomplete.