Kenmore Refrigerator 795.71062010 (79571062010, 795 71062010) Parts

Secures and pivots the ice bank door for smooth opening and proper sealing. Replace if door sags, won't close, or ice dispenser misaligns. Confirm fit.

Refrigerator door spring that provides tension for smooth door operation. Replace if spring is broken, stretched, worn, or missing for proper closure.

Replace your refrigerator's LED light assembly when interior lighting dims or fails. Restores bright, energy-efficient illumination. Verify fit with model number.

Replace a cracked, missing, or discolored refrigerator drain cover. This decorative trim conceals the drain opening and keeps debris out.

A replacement cover motor that powers the refrigerator's dispenser cover, allowing the door to open and close so you can access ice and water. Replaces a worn or failed motor to restore normal dispenser cover operation. What it does:

• Drives the dispenser cover mechanism so the cover opens when dispensing and closes when idle
• Helps keep the dispenser sealed to reduce drafts and prevent pests or debris from entering
• Stops or fails to move when worn, causing a stuck, slow, or noisy dispenser cover
• Works with the dispenser linkage and gears to coordinate cover motion with user controls

What's included:

• One cover motor

Install notes:

• Disconnect power to the appliance before beginning any repair
• Remove dispenser trim and access panel per your model's service instructions to reach the motor
• Handle gears and linkage carefully; ensure proper alignment during reassembly and test cover operation before finishing

Fixes unresponsive control panel, blank display, or non-working touchpad on your refrigerator. This display power control board restores interface functionality.

Replaces a worn, cracked, or broken refrigerator door hinge assembly. Installs on the door frame to restore proper alignment and smooth operation.

Replacement mounting screw for refrigerator panels, trim, and components. Secures loose or missing fasteners to reduce vibration and keep parts in place.

Replaces a damaged, cracked, or missing exterior cover panel on your refrigerator. Restores appearance and protects internal components from dust.

Molded trim piece that snaps over the refrigerator door hinge. Replace if cracked, broken, or missing to restore appearance and protect hinge area.

This is a rear end cap that attaches to the refrigerator door handle, providing a finished appearance at the handle's end. It snaps or fastens onto the handle assembly to secure it in place. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or look incomplete.

This is a protective case assembly that houses the printed circuit board (PCB) for the refrigerator's ice dispenser or display panel. It encloses and shields the electronic control board from moisture and physical damage. Replace this assembly if the housing is cracked, melted, or damaged, or if you need to access or replace the control board inside.