Kenmore Refrigerator 795.71079012 (79571079012, 795 71079012) Parts

Secures components in your refrigerator assembly, reducing vibration and keeping parts properly seated. Replace when damaged or missing to restore snug fit. Verify model compatibility before ordering.

Seals refrigerator door to maintain temperature and prevent energy loss. Replace when worn, cracked, or allowing air leaks. Verify fit with model number.

Leveling leg for refrigerators. Installs at bottom corner to elevate and stabilize the appliance. Replace if broken, compressed, or no longer secure.

Plastic trim cap that snaps over exposed fasteners and mounting posts on your refrigerator. Replace if cracked, broken, missing, or discolored.

Secures and pivots the ice bank door for smooth opening and proper sealing. Replace if door sags, won't close, or ice dispenser misaligns. Confirm fit.

This is a rear end cap that attaches to the end of the refrigerator door handle. It provides a finished appearance and secures the handle in place. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or look incomplete.

A replacement cover motor that powers the refrigerator's dispenser cover, allowing the door to open and close so you can access ice and water. Replaces a worn or failed motor to restore normal dispenser cover operation. What it does:

• Drives the dispenser cover mechanism so the cover opens when dispensing and closes when idle
• Helps keep the dispenser sealed to reduce drafts and prevent pests or debris from entering
• Stops or fails to move when worn, causing a stuck, slow, or noisy dispenser cover
• Works with the dispenser linkage and gears to coordinate cover motion with user controls

What's included:

• One cover motor

Install notes:

• Disconnect power to the appliance before beginning any repair
• Remove dispenser trim and access panel per your model's service instructions to reach the motor
• Handle gears and linkage carefully; ensure proper alignment during reassembly and test cover operation before finishing

Fixes unresponsive control panel, blank display, or non-working touchpad on your refrigerator. This display power control board restores interface functionality.

Replacement mounting screw for refrigerator panels, trim, and components. Secures loose or missing fasteners to reduce vibration and keep parts in place.

This is a black plastic end cap that attaches to the refrigerator door handle to provide a finished appearance and help secure the handle in place. It snaps onto the end of the handle assembly. Replace this cap if it is cracked, broken, or missing, which can cause the handle to feel loose or detract from the refrigerator's appearance.

This is a protective case assembly that houses the printed circuit board (PCB) for the refrigerator's ice dispenser or display panel. It encloses and shields the electronic control board from moisture and physical damage. Replace this assembly if the housing is cracked, melted, or damaged, or if you need to access or replace the control board inside.

Replace your cracked, broken, or missing right-side refrigerator door handle. Restores smooth door operation and matches original appearance.

Replacement door hinge for bottom-mount refrigerators. Installs on the cabinet to support and pivot the door. Needed when hinge is cracked or broken.

Replacement door hinge assembly for your refrigerator. Installs on the cabinet to support the door. Replace if cracked, bent, or worn for proper alignment.