Kenmore Refrigerator 795.75193401 (79575193401, 795 75193401) Parts

Protective grille cover that shields the cooling fan and directs airflow in your refrigerator. Replace if cracked, broken, or missing to restore finish.

Secures bracket assemblies inside your refrigerator to keep components aligned and reduce vibration. Replace if cracked, bent, or missing.

This center hinge assembly supports and pivots the middle door section to keep doors aligned and operating smoothly. Replace a worn or damaged center hinge to restore proper door movement and help maintain a tight seal. What it does:

• Provides the pivot point and structural support for the center door section to open and close smoothly
• Helps maintain door alignment to prevent rubbing, scraping, or uneven gaps
• Reduces door sag that can interfere with sealing and cooling efficiency
• Prevents binding or sticking during door operation

• One center hinge assembly

• Disconnect power to the appliance before starting any repair
• Doors are heavy—have a second person assist to support doors while removing or installing the hinge
• Remove any trim or covers to access hinge screws; align doors fully before tightening fasteners
• Use manufacturer-recommended torque; do not overtighten screws or force parts into place

Replacement door handle for refrigerators. Installs on the exterior door. Replace when your original handle is cracked, broken, loose, or missing.

Motor running loud or vibrating excessively? This motor mounting bracket secures the motor to the cabinet, reducing vibration and noise for stable operation.

Refrigerator shelf support holder that secures shelving in place. Replace if cracked, broken, or missing to restore proper shelf stability and support.

Replacement wire harness connector for refrigerators. Restores secure electrical connections between wiring and control components. Needed when damaged or worn.

Cap cover for bottom-mount refrigerators. Installs to conceal screws or openings. Replace if cracked, broken, or missing for a finished appearance.

Replacement cap cover for your refrigerator. This plastic cover snaps into place to conceal hardware or protect internal components. Order now if broken or missing.

Replacement mounting screw for refrigerator assembly. Secures panels, brackets, or components. Needed when original screw is stripped, lost, or damaged.

This drum support roller helps the dryer drum rotate smoothly and quietly by reducing friction between the drum and cabinet. Replacing a worn roller restores stable drum movement and cuts down on noise and wear. What it does:

• Supports the dryer drum so it turns evenly during cycles
• Reduces squealing, grinding, or rumbling caused by worn bearings or flat spots
• Helps prevent drum wobble and uneven clothing tumbling
• Low-friction bearing surface prolongs drum and belt life

• Power off and unplug the appliance before starting any repair
• Access usually requires removing the dryer front or rear panel and drum—follow your model's service instructions
• Inspect the shaft, hanger, and adjacent rollers or glides; replace any other worn parts to avoid premature failure

Rubber damper bumper for refrigerators. Installs to reduce vibration and noise. Replace if worn, cracked, or missing to restore cushioning support.

Lower door hinge assembly for bottom-mount refrigerators. Mounts the lower refrigerator door to the cabinet. Replace if cracked, broken, or worn.