Kenmore Refrigerator 795.77719700 (79577719700, 795 77719700) Parts

This restrainer is a small retaining clip that helps secure moving or removable components in place, reducing rattles and keeping parts aligned for reliable operation. It's a simple replacement for worn or broken clips. What it does:

• Holds a cover, panel, or door-related component in proper position to prevent shifting
• Reduces noise caused by loose or vibrating parts
• Restores original fit where a broken or missing clip allows movement
• Simple mechanical function — no electrical connections or calibration

• One restrainer

• Disconnect power (and water if applicable) before beginning repairs
• Inspect surrounding mounting points for damage; replace any broken tabs or fasteners
• Typically installs with basic hand tools; align clip and press or snap into place until secure

Structural bracket that secures the refrigerator cover panel to the frame. Replace if cracked, bent, or broken to restore proper alignment and fit.

Ice bucket cracked or missing? This ice storage bin holds ice produced by your refrigerator's ice maker. Restores proper ice containment and hygiene.

Fixes refrigerator water dispenser not working or touchpad not responding. Restores electronic control and power to dispenser components. Moderate difficulty.

Replacement mounting screw for refrigerator panels, trim, and components. Secures loose or missing fasteners to reduce vibration and keep parts in place.

Replacement door handle for refrigerators. Installs on the exterior door. Replace when your original handle is cracked, broken, loose, or missing.

Cover plug for refrigerators. Installs over mounting holes or openings to provide a finished appearance. Replace if cracked, broken, or missing.

Cap cover for bottom-mount refrigerators. Installs to conceal screws or openings. Replace if cracked, broken, or missing for a finished appearance.

Replacement cap cover for your refrigerator. This plastic cover snaps into place to conceal hardware or protect internal components. Order now if broken or missing.

Lower cover assembly for bottom-mount refrigerators. Replaces cracked, broken, or missing lower covers. Installs at the base of the refrigerator.

Protective cover assembly that shields the printed circuit board (PCB) in your refrigerator. Replace if cracked, broken, or missing to protect electronics.

Replacement mounting bolt for refrigerator components and assemblies. Needed when original fastener is missing, stripped, or damaged during service work.

This drum support roller helps the dryer drum rotate smoothly and quietly by reducing friction between the drum and cabinet. Replacing a worn roller restores stable drum movement and cuts down on noise and wear. What it does:

• Supports the dryer drum so it turns evenly during cycles
• Reduces squealing, grinding, or rumbling caused by worn bearings or flat spots
• Helps prevent drum wobble and uneven clothing tumbling
• Low-friction bearing surface prolongs drum and belt life

• Power off and unplug the appliance before starting any repair
• Access usually requires removing the dryer front or rear panel and drum—follow your model's service instructions
• Inspect the shaft, hanger, and adjacent rollers or glides; replace any other worn parts to avoid premature failure

Lower door hinge assembly for bottom-mount refrigerators. Mounts the lower refrigerator door to the cabinet. Replace if cracked, broken, or worn.