Kenmore Refrigerator 795.78412800 (79578412800, 795 78412800) Parts

Genuine Lg part

Holder Assm.,Gasket

By: Lg

Part Number: 4931JJ3002A

Genuine Lg part

Spring

By: Lg

Part Number: 4970JA3044A

Genuine Lg part

Spring

By: Lg

Part Number: 4970JA3045A

Genuine Lg part

Air Duct Gasket

5.0 (1)

By: Lg

Part Number: 4987JA3025H

Do-It-Yourself Stories from Customers like You My LG refrigerator ice maker was leaking water inside the ice maker cavity in the left side door in addition I was getting moisture around the ice door seal and the cold air ducts James W. • Seal Beach , CA • October 20, 2018

I replaced the ice maker assembly, which included the motor and electronics. I also replaced the door seal and the input cold air duct seals. The ice maker is mounted with only 2 philips screws, so it is easy to remove. The most difficult part is the harness, specifically the ground screw. The issue is that the wire is short and you need to turn the unit in order to get a screwdriver in. It would help to have a short screwdriver, but I was, finally, able to remove it with the full length... Read more

Genuine Lg part

Door Basket Assembly

By: Lg

Part Number: 5005JJ2021E

Genuine Lg part

Rubber,Motor-F

By: Lg

Part Number: 5040JA2004B

Genuine Lg part

Condenser Assembly,Wire

By: Lg

Part Number: ACG73746801

Genuine Lg part

Gasket Assembly (Door)

By: Lg

Part Number: ADX73410701

This genuine door gasket assembly creates a tight seal around the appliance door to prevent air and moisture loss, helping the appliance maintain temperature and operate efficiently. What it does:

Seals the door opening to stop air leaks and reduce energy loss
Helps prevent condensation, spills, and drafts from escaping the cabinet
Restores proper door closure and improves temperature consistency
Commonly replaced when the existing gasket is torn, warped, or no longer seals

What's included: One door gasket assembly as shown Install notes:

Disconnect power (and water, if applicable) before starting any repair
Remove the door or access trim to access the gasket mounting channel
Inspect the door flange and gasket seating surface; clean debris before installing the new gasket
Use only manufacturer-recommended fasteners and replace any damaged retainers; test door operation and seal after installation