Kenmore Washer 796.40021900 (79640021900, 796 40021900) Parts

Secures the washer’s tub and basket during moving to prevent internal damage. If the originals are missing after a move, install replacements for transport and remove them before using the washer.

What it does

• Locks the tub and basket to limit movement in transit
• Helps prevent suspension damage and internal rattles while relocating
• Replaces missing, bent, or stripped transport bolts
• Useful for moves, storage, or service shipments

What’s included
One shipping bolt assembly (sold individually).

Install notes

• Unplug power and turn off water before service
• Insert through the rear panel into the designated mounting point; tighten snugly—don’t overtighten
• Do not operate the washer with shipping bolts installed; remove all bolts after placement
• Some models use multiple bolts and lengths—match count/positions to your owner’s manual

Usage tip
After removal, bag and tape the bolts to the cabinet so they’re on hand for the next move.

Replaces a broken, cracked, or corroded spider arm in your washer drum. This 3-leg support connects the inner basket to the drum shaft assembly.

Pivot hanger assembly that supports and stabilizes washer components. Replace if worn, damaged, or causing misalignment to restore smooth movement.

Locking pin for shock absorber.

Rear housing panel that shields internal components and maintains airflow. Replace this outer cover if cracked, broken, or missing to restore protection.

Secures internal washer components and maintains proper alignment. Replace when brackets are worn, broken, or causing rattling. Confirm fit with your model number.

Cabinet base assembly for washers. Replaces cracked, rusted, or corroded base frames. Installs at bottom of washer cabinet to support unit weight.

Air chamber dome for washer pressure systems. Installs on the tub assembly to regulate water level sensing. Replace if cracked, damaged, or missing.

Drum bearing bushing for washers. Installs between drum and bearing assembly. Replace if cracked, worn, or missing to restore proper drum support.

Leveling leg assembly for washers and laundry centers. Installs at the base to support and level the unit. Replace if cracked, broken, or missing.

Washer manual holder that secures care guide documentation to your appliance. Replace if cracked, broken, or missing to keep owner's manual accessible.

This frame assembly is the outer trim piece that restores the appliance's finished appearance and helps hold adjacent panels or components in place. It replaces damaged or missing trim to improve fit and seal. What it does:

• Provides a finished edge and structural support for the appliance front or access panel
• Helps keep adjacent panels aligned and reduces gaps where dirt or moisture can enter
• Restores proper mounting points for switches, bezels, or door panels when the original is cracked or broken
• Commonly replaced for visible damage, warped trim, or when the frame no longer secures nearby components

• One frame assembly

• Disconnect power before starting and remove any connected water lines if applicable
• Handle trim carefully to avoid scratching the finish and to prevent personal injury from sharp edges
• Installation typically requires removing outer panels and fastening the frame with existing screws or clips; keep removed hardware for reassembly

Comes with 2 pins.