Kenmore Dryer 796.90272900 (79690272900, 796 90272900) Parts

Dryer won't heat or stops mid-cycle? This gas burner valve assembly controls fuel flow to the igniter. Moderately challenging repair with basic tools.

This is the front bulkhead panel that forms the front wall of the dryer drum opening. It provides structural support for the drum and typically includes the felt seal and bearing surfaces that allow the drum to rotate smoothly. Replace this assembly if the front panel is cracked, warped, or worn, or if you notice excessive noise, drum wobble, or clothes getting caught between the drum and the front panel.

Metal mounting bracket that secures internal dryer components to the frame. Replace if cracked, bent, or broken to restore proper alignment and stability.

Base bracket for dryer installation and structural support. Replace if your original bracket is cracked, broken, bent, or missing to restore proper stability.

Mounting bracket that secures internal dryer components. Replace if cracked, broken, or missing to restore proper alignment and stability of assemblies.

Dryer duct assembly that connects the drum to the blower housing. Replace if cracked, damaged, or has torn foam seals around openings.

This power cord assembly supplies AC power to the appliance and restores safe operation after a damaged or faulty cord. It replaces the worn or frayed factory cord so the appliance can power on reliably. What it does

• Provides the main AC connection between the appliance and household power
• Replaces cords with visible damage, exposed wiring, burnt connectors, or intermittent power
• Helps stop arcing, sparking, or overheating caused by a failing cord
• Fits into the appliance's cord terminal block for a direct, plug-in power connection

• One power cord assembly

• Disconnect power at the breaker or unplug the appliance before starting any work
• Tighten all terminal screws securely and route the cord away from sharp edges and moving parts

This is the rear section of the dryer drum that forms the back wall of the tumbling chamber. It supports the drum structure and works with the front panel and drum seal to contain clothes during the drying cycle. Replace this part if it is cracked, warped, or damaged, which can cause unusual noises, poor tumbling performance, or air leaks that reduce drying efficiency.

Inner door frame for dryers. Secures the door glass and outer panel assembly. Replace if cracked, warped, or broken to restore door structure and seal.

Wire harness assembly for dryers. Connects electrical components inside the control panel or cabinet. Replace if wires are frayed, damaged, or connectors are broken.