Lg Refrigerator 78002 Parts

Replaces a cracked or broken freezer shroud in your top-mount refrigerator. This air duct cover directs cold airflow in the freezer compartment.

Replacement water injection tube for your refrigerator. Routes water to the ice maker or dispenser. Install when original is cracked, kinked, or leaking.

This fan assembly circulates air through the appliance so coils and internal components operate at the proper temperature. Replacing a failed or noisy fan can restore airflow and help prevent performance issues caused by weak circulation.

• Moves air across coils and components to support designed cooling/dehumidifying performance
• Helps maintain steady airflow to reduce overheating or icing conditions
• A failing fan can cause little to no airflow even when the unit is running
• Common symptoms: fan not spinning, intermittent operation, loud rattling/grinding, vibration, or thermal shutdown

• Disconnect power before servicing to avoid electrical shock or injury
• Access the fan area per your unit's service information; remove panels/shrouds as needed
• Note wire connections and mounting order; transfer any brackets, grommets, or hardware from the old assembly
• After installation, ensure the fan spins freely and clears all shrouds, then test operation before reassembly

This is the rubber door gasket (seal) that lines the edge of the freezer door on a refrigerator. It creates an airtight seal when the door is closed to maintain proper temperature and prevent cold air from escaping. Replace this gasket if you notice frost buildup inside the freezer, the door does not seal tightly, or if the gasket is torn, cracked, or warped.

This is a genuine replacement screw used to secure appliance panels and components. It restores proper fastening so panels and assemblies stay aligned and operate safely. What it does:

• Fastens panels, brackets, and small assemblies to maintain structural integrity
• Replaces missing or stripped screws that cause rattling or loose parts
• Helps stop vibration-related noise when used in its original mounting locations
• Matches the OEM fit to ensure proper alignment and clearance

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or component damage
• Disconnect power to the appliance before working on electrical components
• Replace all matching fasteners for even fit

Snap-in hole plug button covers unused panel openings on refrigerator doors and control panels. Replaces broken, missing, or cracked plugs.

Fixes refrigerator intermittent power issues, control failures, or no-start conditions. This main wiring harness reconnects damaged circuits quickly.

Refrigerator not cooling or defrosting improperly? The main control board manages cooling cycles and defrost timing. Essential for proper operation.

Refrigerator hose clamp band secures water lines and hoses. Replace if cracked, loose, or causing leaks. Verify fit with your model number before ordering.

Plastic cap that covers and protects components in your top-mount refrigerator. Replace if cracked, broken, discolored, or missing for a clean finish.

Routing sleeve that supports and protects rods, shafts, or cables inside your refrigerator. Replace if cracked, broken, or missing to maintain alignment.

Replaces a cracked, broken, loose, or missing refrigerator door handle. Restores secure grip and smooth operation for safe opening and closing.

This sheath heater is the replacement heater housing that surrounds and protects the dryer's heating element, helping deliver consistent, directed heat for efficient drying. It restores proper heater alignment and containment for safe operation. What it does:

• Houses and protects the heating element and terminals from direct contact and damage
• Directs and focuses heat into the drum area for more even drying
• Can prevent shorting or arcing by isolating element wiring and connections
• Commonly used when dryers produce little or no heat, take unusually long to dry, or show visible element damage

• Disconnect power to the appliance before starting any repair — electric shock risk.
• Handle the heating element area carefully; do not bend or nick the element or sheath.
• Follow OEM instructions for mounting orientation and wire routing; replace any damaged clips or fasteners.