Lg Dryer 79671552610 Parts

Mounting bracket that secures internal dryer components. Replace if cracked, broken, or missing to restore proper alignment and stability of assemblies.

Dryer duct assembly that connects the drum to the blower housing. Replace if cracked, damaged, or has torn foam seals around openings.

This kit includes both the high-limit thermostat and the safety thermostat used in a dryer's heating system. These thermostats monitor the internal air temperature and cut power to the heating element if the dryer overheats, preventing potential fire hazards. Replace this assembly if the dryer is not heating, shuts off prematurely, or runs excessively hot.

Horizontal bar connector for dryer assembly. Replace if broken, cracked, or missing to restore proper structural connection between components.

Top panel assembly covers and protects the top of your dryer. Replace if cracked, dented, warped, or damaged from wear. Reuses existing hardware.

This is the rear tub drum for the washer's drum assembly; it supports the inner drum and helps keep loads balanced so the washer can tumble and spin properly. Use this part to restore stable drum rotation and reduce rubbing or banging noises. What it does:

• Supports the inner wash basket and maintains proper alignment during spin cycles
• Keeps the drum centered to prevent rubbing against the cabinet or seal
• Helps reduce loud banging, wobbling or excessive vibration during operation
• Works with the tub seals, bearings and suspension to maintain smooth rotation

• One rear tub drum

• Disconnect power and water before beginning any repair
• This is a major drum component; expect to remove the outer cabinet and other assemblies to access it
• Support the inner drum while separating components; bearings, seal and hardware may need inspection or transfer

Replace your dryer drum assembly if clothes aren't tumbling, you hear scraping noises, or the drum won't rotate. Moderate DIY repair in 1-2 hours.

Base bracket for dryers. Mounts to the bottom of the cabinet to secure the base assembly. Replace if bracket is cracked, bent, or missing hardware.

Dryer holder clip secures components in place during operation. Replace if broken, loose, or missing to prevent rattling and ensure proper part alignment.

If your washer won't fill with water or leaks during fill cycles, a damaged inlet hose is often the cause. This hose restores proper water flow.

Fix a dryer that won't start, stops mid-cycle, or has no display. This main power control board manages electrical controls and restores function.

Secures and supports dryer panels and structural components to restore proper alignment. Replace if cracked, broken, or worn to stop panel rattling.

Small trim cap that snaps over exposed screws and mounting holes on your dryer. Replace if cracked, broken, or missing to restore a clean finish.

Safety cover cap for dryers and laundry centers. Protects internal components and covers exposed areas. Replace if cracked, broken, or missing.