Lg Microwave 86100 Parts

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

This replacement mounting bracket secures internal panels or components to keep assemblies aligned and stable, helping restore proper fit and reduce vibration or looseness. What it does

• Provides a secure mounting point for appliance panels or internal parts
• Restores proper alignment to reduce rattling, vibration, or shifting components
• Helps prevent further wear caused by loose fittings or misaligned assemblies
• Compatible where OEM bracket 4810W3C003A is specified

• One mounting bracket

• Inspect surrounding hardware and mounting surfaces for damage before installing
• Use the OEM screw/fastener locations and torque to avoid stripping or distortion
• Disconnect power and follow appliance safety guidelines before starting repair

This timer motor drives the appliance's mechanical timer assembly so the selected cycle advances and functions correctly. Replaces a worn or failed timer motor to restore normal cycle progression and timing. What it does

• Spins the timer cams/gears to advance cycles so wash/dry steps start and stop in sequence
• Helps engage cycle-specific functions tied to timer position (e.g., fill, agitate, spin)
• Common symptom: timer won't advance or cycles stop mid-cycle
• If you hear the motor humming but the timer shaft doesn't turn

• Disconnect power before attempting any repairs to avoid shock or injury
• Access requires removing the control/timer housing—keep fasteners and small parts organized
• Verify electrical connections and harness before replacement; test for proper operation after installation

A protective plastic or resin shield that covers the microwave's waveguide or other internal components from food splatter and damage. Located on the interior ceiling or side wall of the microwave, it should be replaced if cracked, burned, melted, or shows signs of arcing damage.