Lg Microwave CDMW12B Parts

The Time Delay Fuse is an OEM part for LG microwaves. This fuse provides a safety mechanism by delaying the flow of electricity, protecting the microwave's electrical components from power surges and ensuring the appliance operates safely. It helps to prevent immediate damage in the event of a power surge or electrical fault, thus prolonging the lifespan of the microwave.

Over time, the time delay fuse can become damaged due to electrical surges, wear and tear, or faulty connections. If the fuse blows, it can disrupt the microwave’s ability to function correctly.

Symptoms of a bad time delay fuse include:

• The microwave not turning on
• No response from the microwave control panel
• The microwave stopping unexpectedly during operation
• Electrical issues or blown circuits in the microwave

This OEM LG part is also compatible with Sears/Kenmore models.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.

This electronic control panel houses the pushbuttons and display that let you select cycles and monitor status. It restores responsive controls and visible cycle information so the appliance responds correctly to user commands. What it does:

• Provides the main user interface for selecting cycles, options, and settings
• Sends user inputs to the appliance control board so selected functions run
• Shows cycle status and error indicators on the display
• Can resolve unresponsive buttons, missing displays, or incorrect cycle selection when faulty

• Disconnect power before servicing to avoid shock or damage
• Handle the display and ribbon cable carefully to avoid cracking or connector damage
• Reuse existing mounting hardware unless new fasteners are explicitly included
• If problems persist after replacement, verify the main control board and wiring harness

This packing assembly cushions and seals key components to reduce vibration and prevent leaks, helping the appliance run quietly and reliably. It's a direct-fit replacement when the original packing is worn or damaged. What it does:

• Provides vibration dampening to protect nearby components and reduce noise
• Seals mating surfaces to help prevent fluid or air leaks where installed
• Restores original fit and alignment for proper component operation
• Useful when existing packing is cracked, compressed, or otherwise degraded

• Intended for technicians or experienced DIYers; the part number matches your appliance before starting
• Power off and disconnect the appliance before access or service to avoid electrical or moving-part hazards
• Remove surrounding panels carefully to avoid damaging clips, wiring, or tubing
• Replace only the packing pieces specified; follow OEM instructions for correct placement and torque

A protective plastic or resin shield that covers the microwave's waveguide or other internal components from food splatter and damage. Located on the interior ceiling or side wall of the microwave, it should be replaced if cracked, burned, melted, or shows signs of arcing damage.