Lg Range GM8155XJB Parts

This heater sheath is the metal housing that surrounds and protects the dryer's electric heating element, helping direct heated air into the drum for normal drying. Replaces a damaged or corroded sheath to restore safe, efficient heating. What it does

• Holds and shields the heating element assembly to prevent contact with other components
• Directs airflow around the heating element so the dryer can produce warm air
• Helps maintain proper element alignment and electrical insulation
• Common symptom: dryer runs but produces little or no heat
• Common symptom: visible damage, rust, or burn marks on the element housing

• One heater sheath (heating element housing) as shown

• Disconnect power (unplug or switch off breaker) before servicing to avoid electric shock
• Handle the heating element and terminals carefully; sharp edges may be present
• Inspect element, thermal fuse, and wiring while the cabinet is open; replace only confirmed faulty parts

This resistor is an electrical replacement component that helps control current in your appliance's circuit, restoring reliable operation and preventing erratic behavior when the original resistor fails. What it does:

• Limits or regulates current to protect and control downstream components
• Helps stabilize electrical signals used by fans, motors, heaters, or control boards
• A failed resistor can cause intermittent operation, error codes, or a non-responsive circuit
• Replacing the resistor can resolve symptoms tied to open or damaged circuitry

• Disconnect power to the appliance before beginning any repair
• Handle the component with care to avoid static damage and avoid bending leads
• Verify correct part placement and wiring against the appliance wiring diagram or service manual

This fixed metal resistor (designation "F") is a replacement electrical resistor used on control and power assemblies to maintain correct current flow in the circuit. Replacing a failed resistor restores proper circuit function and helps the appliance operate reliably. What it does:

• Limits or stabilizes current in the control/power circuit to protect components
• Failsafe symptom: appliance control errors, loss of specific function, or intermittent operation
• Often located on or near control boards or power modules where it regulates voltage/current
• Used when a resistor shows open, shorted, or out-of-spec resistance during diagnosis

• One fixed metal resistor (marked "F")

• Disconnect power to the appliance before any service to avoid electric shock
• Verify resistor value and polarity (if applicable) with a multimeter before replacement
• Handle boards and components with ESD care to avoid damage