Lg Range HC302SDA6 Parts

This fixed metal resistor (designation "F") is a replacement electrical resistor used on control and power assemblies to maintain correct current flow in the circuit. Replacing a failed resistor restores proper circuit function and helps the appliance operate reliably. What it does:

• Limits or stabilizes current in the control/power circuit to protect components
• Failsafe symptom: appliance control errors, loss of specific function, or intermittent operation
• Often located on or near control boards or power modules where it regulates voltage/current
• Used when a resistor shows open, shorted, or out-of-spec resistance during diagnosis

• One fixed metal resistor (marked "F")

• Disconnect power to the appliance before any service to avoid electric shock
• Verify resistor value and polarity (if applicable) with a multimeter before replacement
• Handle boards and components with ESD care to avoid damage

This bipolar transistor is a direct-replacement switching transistor used on control boards to help regulate and switch low-voltage currents. Replacing a failed transistor restores reliable circuit switching for affected appliance functions. What it does

• Acts as a semiconductor switch or amplifier on control electronics to enable or interrupt current flow.
• Commonly used to drive motors, solenoids, relays, or other control circuits on the board.
• Failures may cause no power to a circuit, intermittent operation, or related electronic error codes.
• Works as part of the control board's power-management and signal-routing functions.

• One bipolar transistor.

• Disconnect all power to the appliance before attempting any repair to avoid shock or damage.
• Handle the transistor and circuit board with ESD precautions; avoid touching component leads.
• Soldering/desoldering skills are typically required.