Lg Cooktop LCG3011 Parts

Uneven flames or poor heat distribution? This gas range burner cap sits atop the burner element to contain and distribute flames evenly for optimal cooking.

A Tap-Tite binding-head screw used to fasten appliance panels and components where a self-tapping metal thread is required. Replaces missing or damaged fasteners to restore secure assembly and reduce vibration or rattling. What it does:

• Creates its own mating thread in thin sheet metal for a secure hold without a nut.
• Holds panels, brackets, and trim in place to prevent looseness or movement.
• Commonly used where stripped, missing, or broken screws cause rattling, misalignment, or parts that won't stay attached.
• Compatible with standard screwdrivers or nut drivers sized to the binding-head.

• Disconnect power and unplug the appliance before working on it.
• Use the correct driver bit to avoid cam-out or head damage.
• Start straight and apply steady pressure; avoid overtightening to prevent stripping the formed threads.
• If the original hole is badly damaged, assess for repair or use of a larger fastener as needed.

Fix weak or uneven flames on your gas cooktop with this surface burner assembly. Restores consistent heat and proper flame pattern for cooking.

This is the orifice holder that sits beneath the surface burner on a gas range, securing the gas orifice in position so fuel is directed properly to the burner head. It ensures a consistent and correctly shaped flame for even cooking. Replace this part if you notice irregular flame patterns, difficulty igniting a burner, or if the orifice is loose or misaligned.

Replace a cracked, discolored, or missing burner cap that's causing uneven flames or allowing spills into the burner assembly. Fits over the burner head.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.

Replaces worn, broken, or missing accessory assembly on your gas cooktop. Restores proper fit and secure connections for related components.

Plate assembly for cooktop burner systems. Replaces cracked, warped, or damaged plates. Essential structural component for proper burner support.

Fix a cooktop that won't turn on or off, or has unresponsive controls with this switch assembly. Moderate difficulty repair typically takes 30-45 minutes.

Replace a gas range burner when flames are uneven, won't ignite, or produce yellow flames. Direct swap installation takes 10-15 minutes with basic tools.

Burner not heating or heating unevenly? This surface element restores full heat output on your range. Straightforward DIY fix in under an hour.