Lg Range LDG3037 Parts

This is a surface burner cap designed for a high-output 17,000 BTU burner on a gas range cooktop. It sits on top of the burner base and distributes the flame evenly in a circular pattern for consistent heating. Replace this cap if it is cracked, warped, discolored, or if the burner flame appears uneven or yellow.

Fixes uneven baking and noisy oven operation. This convection fan assembly circulates hot air for consistent cooking. Moderate DIY repair restores airflow.

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

If your gas range burner won't light or produces uneven flames, this surface burner assembly restores proper ignition and even heat distribution.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

The range packing seal creates an airtight barrier around oven doors or other range components to maintain proper cooking temperatures and prevent heat loss. Positioned around door edges or component joints, it needs replacement if heat escapes, cooking becomes uneven, or the seal appears cracked or compressed.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are damaged, frayed, burned, or connections are loose.

Replace a failed power control board when your range won't turn on, has no display, or loses power to burners. Restores electrical distribution to all components.

Secures the door hinge to the range cabinet for proper alignment. Replace this bracket if it's cracked, bent, or missing to restore stable door support.

Mounting bracket for gas ranges. Secures components in place during operation. Replace if bracket is bent, cracked, broken, or missing hardware holes.